Abstract:Dielectric elastomers (DEs) used for energy conversion are often subjected to dc voltages or low-frequency varying voltages where the influence of space charge accumulation should be considered. The accumulation of space charge distorts the local electric field in the dielectric, which is closely related to critical dielectric performance, such as breakdown and electrical aging. Little research has been done on the effect of space charge in DE on the breakdown performance. In previous studies, it has been shown that adding nanosized silica may improve the breakdown strength, which is often ascribed to the traps created by the nanoparticles. Charge trapped in front of the electrode-dielectric interface is supposed to reduce the electric field and hence reduce charge injection and accumulation, resulting in a higher breakdown strength. In this article, to test this hypothesis, PDMS samples are prepared with different concentrations of nanosilica, as well as reference samples without filler. These specimens are characterized through space charge measurements. Conduction current measurements are performed to obtain additional information on the injection current. To relate space charge accumulation to a change in the breakdown characteristics, different types of breakdown tests are performed under ac and dc voltage. First, ac and dc ramp voltages are used, with the hypothesis that any accumulated space charge will have an effect only on dc breakdown because ac stress at power frequency does not allow enough time for space charge accumulation. In an additional step, step-up dc voltage tests are performed with the duration of each step long enough to allow space charge accumulation. The hypothesis in this case is that, due to the effect of space charge, the dc breakdown voltage would be lower than under dc ramp tests. The results of these experiments show that in the reference specimens, the breakdown strength is indeed affected by a strong build-up of space charge. Furthermore, the space charge can be mitigated by adding a small fraction of nanosilica. This mitigation of space charge accumulation is shown to lead to a significantly higher dc breakdown strength, whereas the ac breakdown strength is hardly affected.

Effect of Applied Mechanical Stress on Induction of Space Charge Breakdown

Space Charge Dynamics in Epoxy Based Composites under DC and Square Pulse Wave of Different Polarities and Frequencies

Phase field modeling of dielectric breakdown of ferroelectric polymers subjected to mechanical and electrical loadings

Effects of Space Charges on DC Breakdown in Low Density Polyethylene

High Repetition Rate Space Charge Measurement of Heat-treated Low-density Polyethylene at Prebreakdown

Space Charge Behavior in Acrylic Elastomer under DC Voltage with and Without Stress

Space Charge and Its Role in Electric Breakdown of Solid Insulation

Space charge behaviour in acrylic elastomer under DC voltage with and without stress

Pre-Stressing Effect on Dc Breakdown in Low-Density Polyethylene

Space Charge in PDMS/SiO2 Nanocomposites under DC Voltage and Its Influence on Breakdown Properties

Influence of Space Charge on Dielectric Property and Breakdown Strength of Polypropylene Dielectrics under Strong Electric Field

Effect of Thermal Pulse on Space Charge Accumulation in LDPE under DC Voltage

Influence Of Applied Voltage On Space Charge Formation And Accumulation Characteristics Of Low Density Polyethylene

Effect of Electrode Material Type on Space Charge Characteristics in Polymers

Space Charge Behavior under Different Electric Fields in Acrylic Elastomer

Influence of Mechanical Stress on Polypropylene Film Partial Discharge

Humidity effect on electromechanical breakdown of dielectric elastomers subject to a ramp voltage

Effects of Surface Topography and Morphology on Space Charge Packet in Polyethylene

Space Charge Distribution Analysis in Polyethylene under High Static Pressure

Reduction of Space Charge Breakdown in E-Beam Irradiated Nano/Polymethyl Methacrylate Composites

Space Charge and Thickness Dependent Dc Electrical Breakdown of Solid Dielectrics