Abstract:This article proposes a configurable supply mechanism in the power stage to simultaneously improve the load transient response and power conversion efficiency. The power stage, comprising a dcdc converter and an auxiliary power circuit (APC), can be organized depending on the variable load conditions. During step-load changes, the APC can provide an additional charging or discharging current to the output capacitance of the dcdc converter to compensate for any differences between the load current and inductor current. Meanwhile, two auxiliary transient transistors are employed to immediately adjust the output level of the error amplifier because the peak current-mode control is used in the dcdc converter. Thus, the recovery time and output transient ripple are enhanced significantly. At the steady state, the APC is inactivated; thus, the conversion efficiency of the dcdc converter does not degenerate. Above medium loads, only the dcdc converter is activated to deliver adequate power with high efficiency. At light loads, the APC acts as a linear regulator to take over the energy delivery scheme because power consumption is reduced effectively while the output voltage is kept. Therefore, the hybrid operation can guarantee improvements in load transient response and power conversion efficiency at light loads. The proposed converter was fabricated with 0.35-m CMOS technology. The experimental results showed that the recovery times for 450-mA step-down and step-up loads are 1.6 and 2.0 s, respectively. Comparing to when the transient mode is disabled, the recovery time of the output voltage is improved by over ten times when the transient mode is enabled. Further, the efficiency improvements with the proposed method at load current of 20 mA under the output voltages of 2.5 V and 1.8 V are 13.8 and 4.9, respectively.

A Current-Mode DC-DC Buck Converter with High Stability and Fast Dynamic Response

A Current-Mode DC-DC Buck Converter with High Stability Independent of Load and Supply Voltage

Implementation of High Stability with On-Chip Frequency Compensation in a Current Mode DC-DC Converter

An Improved Optimum-Damping Current-Mode Buck Converter With Fast-Transient Response and Small-Transient Voltage Using New Current Sensing Circuits

A Monolithic High-Performance Buck Converter with Enhanced Current-Mode Control and Advanced Protection Circuits

System modeling and stability design for peak current-mode buck power converter

A Fast Transient Current-Mode Buck Converter With Linear Regulation Mode

Discrete-Time Poles and Dynamics of Discontinuous Mode Boost and Buck Converters Under Various Control Schemes

Constant off-Time Digital Current-Mode Controlled Boost Converters With Enhanced Stability Boundary

A High Efficiency Buck DC/DC Converter Based on Adaptive Constant On-Time

Design of DC-DC Buck Converter Based on Improved Voltage-mode COT Control

Design of Peak-Current-Mode-Controlled Buck DC/DC Converter Chip

A Fast Transient Response Slope-Adjusted Voltage Mode Buck Converter

A New Improved Ultra-Fast-Response Low-Transient-Voltage Buck Converter With Transient-Acceleration Loops and V-Cubic Techniques

Dynamic Analysis of Multimode Buck–Boost Converter: an LPV System Model Point of View

Design of Fast Transient Response Voltage-Mode Buck Converter With Hybrid Feedforward and Feedback Technique

Design-oriented fast response voltage mode buck converter with adaptive ramp control

Accurate Loop Gain Modeling of Digitally Controlled Buck Converters

A dual-mode digital controller with a high accuracy load current estimator and Gaussian adaptive duty cycle switching for fast transient recovery in DC-DC buck converters

Stability Study on Current-Mode Controlled Buck Converter With Input Filter Based on Improved Discrete Approach

A Current Mode Buck/Boost DC-DC Converter with Automatic Mode Transition and Light Load Efficiency Enhancement