Abstract:The burgeoning interest within the space community in digital beamforming is largely attributable to the superior flexibility that satellites with active antenna systems offer for a wide range of applications, notably in communication services. This paper delves into the analysis and practical implementation of a Digital Beamforming and Digital Down Conversion (DDC) chain, leveraging a high-speed Analog-to-Digital Converter (ADC) certified for space applications alongside a high-performance Field-Programmable Gate Array (FPGA). The proposed design strategy focuses on optimizing resource efficiency and minimizing power consumption by strategically sequencing the beamformer processor ahead of the complex down-conversion operation. This innovative approach entails the application of demodulation and low-pass filtering exclusively to the aggregated beam channel, culminating in a marked reduction in the requisite digital signal processing resources relative to traditional, more resource-intensive digital beamforming and DDC architectures. In the experimental validation, an evaluation board integrating a high-speed ADC and a FPGA was utilized. This setup facilitated the empirical validation of the design's efficacy by applying various RF input signals to the digital beamforming receiver system. The ADC employed is capable of high-resolution signal processing, while the FPGA provides the necessary computational flexibility and speed for real-time digital signal processing tasks. The findings underscore the potential of this design to significantly enhance the efficiency and performance of digital beamforming systems in space applications.

FPGA Realization of Downlink Digital Beam Forming Calibration

FPGA implementation of downlink DBF calibration

A Simple Over-The-Air Hardware Calibration Procedure In Tdd Systems

A simplified DBF channels calibration algorithm and implementation

Design and Measurement of Signal Processing System for Cavity Beam Position Monitor

Design of rf front end for cavity beam position monitor based on ics *

Calibration of a Digital Phased Array by Using NCO Phase Increasing Algorithm

Implementation and Integration of a Systematic DBPM Calibration with PLL Frequency Synthesis and FPGA

A Frequency-Domain I/Q Imbalance Calibration Algorithm for Wideband Direct Conversion Receivers Using Low-Cost Compensator.

Research on Digital Beam Forming System Design Based on FPGA.

Design and implementation of high-precision synchronized wireless

Digital Beam Forming Based on PDLMS Algorithm and Its Implementation Using FPGA

Study on the Calibration of Receiving Channels and the Beamforming Technology for Wideband Digital Array Antennas

The Design and Hardware Implementation of OFDM System Receiver Based on FPGA

Wideband Beamforming Based on Farrow Structure

Neural Calibration for Scalable Beamforming in FDD Massive MIMO with Implicit Channel Estimation

Real-Time Phase Correction Based on FPGA in the Beam Position and Phase Measurement System

A Digital Beamforming Receiver Architecture Implemented on a FPGA for Space Applications

Hardware Implementation Of Music Algorithm For Airborne Digital Direction Finding System

FPGA-Based Real-time Interference Alignment Verification System

Calibration of Wideband LFM Radars based on Sliding Window Algorithm