Abstract:In the machining of complicated surfaces, the cutters with large length/diameter ratios are used widely and the deformation of the machining system is one of the principal error sources. During the process planning stage, the cutting direction angle, the cutter lead and tilt angles are usually optimized to minimize the force induced error. It may lead to a low machining efficiency for bullnose end mills, as the material removal rates are different largely for different machining angles. In this paper, the influence mechanism of the machining angles on the force induced error is studied based on the models of the instantaneous cutting force when the cutter flute traveling through the cutting contact point and the stiffness of the machining system. In order to evaluate the machining angles, the force induced error/efficiency indicator (FEI) is defined as the division of the force induced error and the equal volume sphere of the removed material. FEI is dimensionless, with the lower FEI, the lower force induced error and the higher machining efficiency. For optimal selection of the machining angles, the critical FEI is calculated with the constraint of force induced error and the desired material removal rate, and the critical FEI separate the set of the machining angles into two subsets. After the feed rate scheduling process, the machining angles in the optimal subset would have higher machining accuracy and efficiency, while the machining angles in the other subset have lower machining accuracy and efficiency. Through the machining experiment of five axis machining and freeform surface machining, the effectiveness and superiority of the proposed FEI method is verified with a bullnose end mill, which can improve the machining efficiency with the constraint of force induced error.

Investigation on Self-generation of Machining Precision and Its Application for Mutual Lapping Machining of End-tooth Indexing Table

Self-generation of Machining Precision and Its Realization in Lapping of Super Precision Solid Balls

Investigation on Self Generation of Machining Precision and Its Realization in Grinding of Solid Balls with Super Precision

Precision Measurement of Z -Slide Vertical Error Motion of an Ultra-Precision Lathe by Using Three-Probe Method

Study on Control Algorithm for Micro-line Interpolation End-point

Influence mechanism of machining angles on force induced error and their selection in five axis bullnose end milling

A New Approach to Improving the Machining Precision Based on Dynamic Sensitivity Analysis

Modeling of the Abrasion of an End-Tooth Indexing Table

Mechanism Analysis for Super-Precision Machining of Small Balls by a 4-Cup Type Lapping Machine

A new toolpath generation method with feed sensitive zones inspection based on inverse evaluation mechanism.

A method of sensitivity analysis and precision prediction for geometric errors of five-axis machine tools based on multi-body system theory

A “double Accuracy Theory” and Experimental Research on Precision Grinding

The Analysis and Optimization of Machining Precision Based on Electromechanical Matching in High-Speed Machine Tools

Research on Life of Machine Accuracy and Precision Reliability Assessment Concerning about a Turn-Milling Combined Machine Tool

On-machine measurement method and geometrical error analysis in a multi-step processing system of an ultra-precision complex spherical surface

An Empirical Approach for Identification of Sources of Machining Errors in Ultra-Precision Raster Milling

Machining Straight-Groove-type Microstructure Arrays with the Three-Axis Ultra-Precision Lathe Assisted by a Rotating Stage Based on the Double Closed-Loop Controller

Design of Compound Machine Tool for Ultra-Precision Shaft Parts

ANALYTICAL MODEL FOR END MILLING SURFACE GEOMEIRICAL ERROR WITH CONSIDERING

Design and development of a precision machine tool using counter motion mechanisms

A Novel Precision Evaluation and Analysis Method for the Direct Driven High-Speed Feed System