Iterative Approach to Scattering from the Targets above a Rough Surface
Hongxia Ye,Ya-Qiu Jin
DOI: https://doi.org/10.2529/piers041202212611
2005-01-01
PIERS Online
Abstract:The difference field RCS from a target above a rough surface is derived. The electric field integral equations (EFIE) of the difference induced currents Jsd on the surface and J0 on target are developed. Because of the strongest scattering in the specular direction, a small interface taken along the converse specular direction is attributed to computation of the surface scattering upon the target. A fast mutual-coupling iterative method is developed to solve the two EFIEs. The interface length for effective computation is discussed. Using the Monte Carlo method, scattering from a target, such as a cylinder and a square column, above the P-M rough surface is numerically simulated. Scattering from a cylinder above the rough surface in the specular direction is enhanced significantly. The Bi-RCS of a square column above the rough surface shows two peaks in forward and backward directions. As a model of rough sea surface, when the surface wind speed increases, the scattering peaks become lower, and more defused scattering shows the angular scattering pattern. Introduction Scattering from the targets above a rough surface has attracted more interests in recent years. In the combined target-surface problem, the difference field cross section was introduced by Johnson [1] to remove the dependence on incident taper wave width. Scattering for the combined target-surface problem and surfaceonly problem are respectively calculated, and their difference shows scattering attributed by the target and interaction between the target and rough surface. In this paper, we derive the EFIEs of the difference induced current on rough surface and current on the target. A mutual-coupling iterative approach is developed to solve the EFIEs. The interface length for the iterative calculation is discussed. As examples, scattering from a cylinder and a square column above a rough surface are simulated. It can be seen that scattering from the cylinder above a rough surface is significantly enhanced in the specular direction due to interactions of the target and the underlying surface. Variation of the difference induced currents on the interface also demonstrates such interactions. Scattering from a square column has two peaks in the backward and forward directions due to its specific geometry. As a model of a target located above the wind-driven sea surface, numerical simulations show the angular pattern of bistatic scattering versus oceanic status. When the surface wind speed increases, scattering peaks become weaker and more angular defused scattering are dominated. Theory and Method In a model of the target above rough surface, both the total and differential cross section are previously related to the surface length illuminated by incident wave. In order to remote the dependence on illuminated surface length, the difference of the scattering field, Es1, attributed by both the target and surface and the scattering field by a rough surface only, Es0, is calculated as Esd, which is used to compute the difference field cross section σd [1], which demonstrates how much the scattering attributed by the target and interaction between the target and underlying rough surface. It does not depend upon the illuminated rough surface length. As shown in Fig.1, a two-dimensional (2D) target (perfect electric conductor, PEC) is located above a 2D PEC rough surface. As the incident tapered wave is incident on the target and rough surface, the induced current on the target is defined as J0, and the induced current on the surface is Js1. The EFIEs are written as [2] 0 = ET (r)− jkη ∫ c Jo(r ′) ·G(r, r′)dr′ − jkη ∫ S Js1(r ′) ·G(r, r′)dr′(r ∈ c) (1) 202 Progress In Electromagnetics Research Symposium 2005, Hangzhou, China, August 22-26