Abstract:With the success of Shenzhou spacecraft rendezvous and docking with Tiangong-1 and Tiangong-2, the future tasks of the space station such as space garbage clean-up requires the control of spacecraft attitude to be more and more accurate. Because of the high cost of the attitude control and regulation test in space, the experiments are usually carried out on the ground. In order to simulate the microgravity environment of space, the gravity of the aircraft model is needed to be overcame in the ground test. Presently, there are two ways that not only overcome the gravity of the aircraft model but also make the aircraft to freedom of movement: one is to use non-contact force to overcome the gravity, such as electromagnetic force, but this approach requires the control of non-contact force to be very accurate, which needs difficult technology and faces the high cost; another way is to use liquid buoyancy to overcome gravity, which only needs to ensure that the average density of the aircraft model is equal to the density of the liquid, and the aircraft model can be suspended at any position in the liquid, using the thrust produced by the propeller to carry out the free movement. This technique is not difficult and low cost, but in the control of aircraft model movement needs to overcome the force and torque generated by the liquid. Therefore, the buoyancy of water is used to overcome the gravity of the vehicle model, and a neutral buoyancy force is obtained. Then the numerical analysis technique is used to calculate the hydrodynamic coefficient of the model. At the same time, by changing the propeller thrust, the response curves of aircraft moving in vertical and horizontal directions are simulated and verified. The results show that the model can reach a new equilibrium state in 0.8~1 seconds. This paper provides a theoretical basis for guiding the tunnel test of aircraft model, which is one of the important links in the iterative design of space vehicles.

Study on the Technique of Barbell Mass and Inertia Simulating of a Docking Simulation Test Bed

Mass and Inertia Simulator for Docking Dynamic Test Bed

Study on the Simulation of the Spacecraft's Inertia and Mass Properties of a Novel Docking Dynamics Test Bed

Research on the Underwater AUV Docking Station with Two Swing Degrees of Freedom

Weightless Simulation Technique of the Active Docking Ring for the Spacecraft Docking Test Table

Dynamic Modeling and Simulation of Thermal Vacuum Test Platform for Spacecrafts Docking

Simulation on HIL Ground Experiment Simulator for On-orbit Docking

Design and Evaluation of Dynamic Equivalent Test Platform for Thermal Vacuum Qualification Test of Docking Units

A Hardware-In-The-Loop Spacecraft Docking Simulation System And Its Stability Analysis

Validation of Simulation Precision on the Docking-dynamic Simulation Experimental Testbed

Low Friction Rotating Technique of Spacing Docking Test Bed

Dynamic Characteristics Simulation for Spacecraft Docking Five-Freedom Test Table

Numerical Simulation of Neutral Buoyancy Experiment for Spacecraft

Dynamic simulation analysis for docking mechanism of on-orbit-servicing satellite

Research on Numeric Simulation of Docking Dynamics Considering Inertia of Shock Absorbers and Contact Deformation

Modeling, Stability Analysis, and Testing of a Hybrid Docking Simulator

10 DOF Physical Docking Dynamics Test Facility

Research on Virtual Hardware-in-the-loop Simulator for On-orbit Docking

Hybrid Realtime Simulation of the Space Docking Process

A Ground Docking Test Facility for Docking Mechanism

Research on Fundamental Problems and the Solutions of HIL Simulation for On-orbit Docking Dynamics