Abstract:Hg(II) imprinted and non-imprinted copolymers were prepared by metal ion imprinted polymer (MIIP) technique. The copolymers were obtained by copolymerizing mercury chloride (or without it), diazoaminobenzene (DAAB) and vinylpyridine (VP) using ethyleneglycoldimethacrylate (EGDMA) as cross-linker in the presence of 2,2′-azobisisobutryonitrile as initiator. The separation and preconcentration characteristics of the copolymers for Hg(II) were investigated by batch and column procedures. The results demonstrated that the Hg(II) imprinted copolymers had higher adsorption capacity with the value of 205μmolg−1 of dry copolymer, about 3.5 times of and good selectivity for Hg(II) compare to non-imprinted copolymers (58.6μmolg−1 of dry copolymer). The distribution ratio (D) values of the Hg(II) imprinted copolymers increased for Hg(II) with respect to both D values of Zn(II), Cu(II), Cd(II), CH3HgCl, CH3CH2HgCl and non-imprinted copolymer. The relatively selective factor (αr) values of Hg(II)/Cu(II), Hg(II)/Zn(II), Hg(II)/Cd(II), Hg(II)/CH3HgCl and Hg(II)/CH3CH2HgCl are 45.5, 63.5, 55.1, 49.6 and 84.0, respectively. The tolerance limit for other electrolytes such as NaCl, KBr, KI, NaNO3, Na3PO4, Na2SO4 and Mg(NO3)2 is also greatly improved with the values of 10–100-fold of the non-imprinted copolymer. The Hg(II) imprinted copolymers can be used at least 20 times with recoveries no less than 95%. Based on the packed columns with Hg(II) imprinted copolymers, a highly selective solid-phase extraction (SPE) and preconcentration method for Hg(II) from dilute aqueous solution was developed. The MIIP-SPE preconcentration procedure showed a linear calibration curve within concentration range from 0.13 to 25μgl−1. The detection limit and quantification limit were 0.05 and 0.13μgl−1 (3σ) for cold vapor atomic absorption spectrometry (CVAAS). The relative standard deviation of the eleven replicate determinations was 2.4% for the determination of 1.0μg of Hg(II) in 100ml water sample. Determination of Hg(II) in certified river sediment sample (GBW 08603) demonstrated that the column was good enough for Hg(II) determination in matrixes containing components with similar chemical property such as Cu(II), Zn(II), Cd(II), CH3HgCl and CH3CH2HgCl.

Preconcentration and Separation of Zn2+ Using Surface Zinc(Ii) Imprinted Functionalized Silica Gel Sorbent

Silica Gel Surface-Imprinted Solid-Phase Extraction of Zr(IV) from Aqueous Solutions

Silica Gel Surface Modified with Sulfanilamide for Selective Solid-Phase Extraction of Cu(II), Zn(II) and Ni(II)

Solid-phase Extraction of Trace Cu(II) Fe(III) and Zn(II) with Silica Gel Modified with Curcumin from Biological and Natural Water Samples by ICP-OES

Chemically modified silica gel with p-dimethylaminobenzaldehyde for selective solid-phase extraction and preconcentration of Cr(III), Cu(II), Ni(II), Pb(II) and Zn(II) by ICP-OES

ICP-OES determination of trace metal ions after preconcentration by 4-(8-hydroxy-5-quinolylazo)naphthalenesulfonic acid modified silica gel

Selective adsorption of Zn2+ on surface ion-imprinted polymer

Selective Solid-Phase Extraction of Lead(Ii) from Biological and Natural Water Samples Using Surface-Grafted Lead(Ii)-Imprinted Polymers

Preparation of p-tert[(dimethylamino)methyl]-calix[4]arene functionalized aminopropylpolysiloxane resin for selective solid-phase extraction and preconcentration of metal ions.

Determination of Trace Metals in Natural Samples by Icp-Oes after Preconcentration on Modified Silica Gel and on Modified Silica Nanoparticles

Selective Solid-Phase Extraction of Nickel(ii) Using a Surface-Imprinted Silica Gel Sorbent

Silica-gel Particles Loaded with an Ionic Liquid for Separation of Zr(IV) Prior to Its Determination by ICP-OES

Zincon-modified activated carbon for solid-phase extraction and preconcentration of trace lead and chromium from environmental samples.

Solid-Phase Extraction And Preconcentration Of Trace Pb(Ii) From Water Samples With Folic Acid Modified Silica Gel

Selective solid phase extraction of trace Sc(III) from environmental samples using silica gel modified with 4-(2-morinyldiazenyl)-N-(3-(trimethylsilyl)propyl)benzamide.

Selective solid phase extraction and preconcentration of mercury(II) from environmental and biological samples using nanometer silica functionalized by 2,6-pyridine dicarboxylic acid

Simultaneous Measurements of Cr, Cd, Hg and Pb Species in Ng L-1 Levels by Interfacing High Performance Liquid Chromatography and Inductively Coupled Plasma Mass Spectrometry.

Solid-phase Extraction of Iron(iii) with an Ion-Imprinted Functionalized Silica Gel Sorbent Prepared by a Surface Imprinting Technique

Solid phase extraction of trace Hg(II) on silica gel modified with 2-(2-oxoethyl)hydrazine carbothioamide and determination by ICP-AES.

Highly selective determination of inorganic mercury(II) after preconcentration with Hg(II)-imprinted diazoaminobenzene–vinylpyridine copolymers

Simultaneous separation and preconcentration of Cr(III), Cu(II), Cd(II) and Pb(II) from environmental samples prior to inductively coupled plasma optical emission spectrometric determination.