Abstract:The Cu materials are playing an irreplaceable role in modern marine facilities, while one major issue affecting their service life is corrosion attack caused by external erosion of chloride ions, which leads to the quickly structural deterioration and reduced durability. To solve this obstinate issue, the corrosion−resistant Ni−based composite films with conductive Yttria–stabilized zirconia (YSZ, 2.5–15 g/L) and non−conductive Si 3 N 4 (2.5–15 g/L) reinforcing phases were composite–electrodeposited on Cu substrate in direct current (DC) mode. It was believed that the electrical differences of incorporated nanoparticles have a significant impact on nucleation and growth behaviors during electrodeposition, which further altered the structure and property of Ni−based composite films. Therefore, the emphasis of this study was to establish the correlation between obtained structure, electrochemical, and immersion corrosion performances at different incorporation levels of YSZ/Si 3 N 4 nanoparticles. The results demonstrate that by increasing the total doping contents, the Electrochemical Impedance Spectroscopy (EIS) and Chronoamperometry (CA) measurements exhibited an initial increase followed by a subsequent decrease on co−deposition dynamics, which was related to the dominant impact of conductive YSZ nanoparticle at electrocrystallization process. Meanwhile, the moderate incorporation level of 15 g/L offered effective control over structural compactness through dispersion−strengthening and grain−refining, and the same ratio of YSZ/Si 3 N 4 nanoparticles further maximized the improvement degree of microhardness, electrochemical passivation, and immersion stability of resulting films. Besides, the corrosion current density ( j corr ) of Ni−YSZ−Si 3 N 4 composite coating under optimum condition of 15 g/L was two orders of magnitude smaller than that of Cu substrate after long−term immersion test, and the corresponding polarization resistance ( R p ) also increased by 8.6 times. Overall, these substantial alterations obtained provide effective guideline for the design and preparation of corrosion−resistant Ni−based composite coating, which is beneficial to prolonging the service life of Cu components in saline environments.

Electrodeposition of Ni-Sic Nanocomposite Coatings Based on the Surface Charge Determination of Sic Nanoparticles

Electrodeposition of Ni-SiC Nanocomposite Film

Electrodeposition and Characterization of Nano-Structured Ni–SiC Composite Films

A Study on the Electrocodeposition Processes and Properties of Ni–SiC Nanocomposite Coatings

Preparation of Ni-Coated SiC Ceramic Composite Powder by Electroless Plating

Electrochemical Properties and XPS Analysis of Ni-B/SiC Nanocomposite Coatings

Nickel Co-Deposition with SiC Particles at Initial Stage

A Specific Chemical Activation Pretreatment for Electroless Nickel Plating on SiC Ceramic Powders

Influence of Electrodeposition Process Parameters and Si3N4 Nanoparticle Concentration on Microhardness and Wettability of Ni-Co-Si3N4 Nanocomposite Coatings

Codeposition of SiC Powders with Nickel in a Watts Bath

CORROSION BEHAVIOR OF THE Ni-SiC NANOCOMPOSITE COATINGS

Impact of Surface Chemistry of Silicon Nanoparticles on the Structural and Electrochemical Properties of Si/Ni3.4Sn4 Com-posite Anode for Li-Ion Batteries

Nucleation Kinetics Analysis of Ni-SiC Composite Film During Early Electrocrystallization Processes

Electroless nickel plating on silicon carbide nanoparticles

Investigation on Microstructure and Properties of the Electrodeposited Ni-SiC Composite Coating

Preparation of Nickel-Cobalt/Carborundum Carbide Composite Coatings by Supergravity Field-Enhanced Electrodeposition

Corrosion Behavior of Nanostructured Ni‐Si3N4 Composite Films: A Study of Electrochemical Impedance Spectroscopy

In Situ Construction of ZnO/Ni2S3 Composite on Ni Foam by Combing Potentiostatic Deposition with Cyclic Voltammetric Electrodeposition

Electrodeposition fabrication of corrosion−resistant Ni–based composite film on surface of Cu: Role of conductive YSZ and non−conductive Si 3 N 4 nanoparticles

Cathode plasma electrolytic deposition of Al2O3 coatings doped with SiC particles

Effect of SiC Nanoparticles on the Structure and Properties of Ni+W-SiC Nanocoatings