Abstract:Nitrogen in coal is a major pollutant that inhibits the effective and extensive utilization of coal, and hence, nitrogen removal during and after coal combustion is of great importance. Future utilization of coal requires accurate knowledge of its structure and properties. Datong coal (DT, bituminous coal), Huolinhe coal (NM, brown coal) and Fushun coal (FS, brown coal) were pyrolyzed in a fixed-bed reactor under argon atmosphere with a heating rate of 15 degrees C/min. X-ray photoelectron spectroscopy (XPS) was used to investigate the presence of nitrogen in the coals and their chars obtained from pyrolysis. The nitrogenous components in the product gases were analyzed by Fourier transform infrared (FT-IR) spectrometer. The results indicate that N-5 is the main nitrogen-bearing compound in DT coal and NM coal, whereas in FS coal N-6 is the main nitrogen-bearing compound. After pyrolysis at 600 degrees C, the quantity of N-6 in the char rises for DT coal, and drops for NM coal and FS coal. After pyrolysis at 1000 degrees C, the quantity of N-6 decreases significantly for FS coal, and considerable quantity of N-Q is detected. NH3, HCN, and NO were identified among the gases resulting from pyrolysis, with the HCN and NO yields being lower than the NH3 yields. In coal pyrolysis, the initial formation temperature of NH3 is approximately the same as that of HCN. The temperatures are almost identical when the concentrations of NH3 and HCN reach their maxima for DT coal and FS coal. The formation of HCN starts at a temperature of about 400 degrees C, and below 700 degrees C, considerable amounts of HCN and NH3 are produced. The amount of nitrogen released increases with the temperature at which pyrolysis takes place, the maximum release rate being 81.28% at 1000 degrees C. Copyright (C) 2010 Curtin University of Technology and John Wiley & Sons, Ltd.

Investigation on HCN and NH3 Formation During Secondary Pyrolysis of Coal Tars

Pyrolysis Behavior of Huainan Bituminous Coal and Formation Characteristic of Tar

Studies on the Formation of HCN and NH3 During Coal Macerals Pyrolysis

Effect of Rank, Temperatures and Inherent Minerals on Nitrogen Emissions During Coal Pyrolysis in a Fixed Bed Reactor

Release of Nitrogen Containing Components During the Pyrolysis of Residues of Shenhua Coal Liquification

Formation of Hcn and Nh3 During Coal Macerals Pyrolysis and Gasification with Co2

Effect of Operating Parameters on Hcn and Nh3 Release from Australian and Chinese Coals During Temperature-Programmed Pyrolysis

Experimental Investigation on the Conversion of Nitrogenous Gas Products During Coal Pyrolysis

Study on the characteristic of nitrogen release for bituminous coal during pyrolysis

Experimental Investigation on Char Nitrogen Conversion During Coal Pyrolysis

Formation of NOx and SOx precursors during the pyrolysis of coal and biomass. Part IV. Pyrolysis of a set of Australian and Chinese coals

Relationship between nitrogenous species in coals and volatile nitrogen-containing yields during pyrolysis

Investigation of the (catalytic) Co-Pyrolysis of Shendong Coal and Coal Tar Based on Rapid Pyrolysis and ANN Modelling

Formation of HCN and NH_3 During the Rapid Pyrolysis of Coal and Model Compounds

Effect of heating rate on the secondary reaction in low-rank coals pyrolysis with the real-time evolution analysis of in-situ tar

Influence of Coal Properties on the Release of HCN During Rapid Pyrolysis of Chinese Coals

Investigation on the Thermal Behavior Characteristics and Products Composition of Four Pulverized Coals: Its Potential Applications in Coal Cleaning

Effects of Some Factors on the Formation of Nox Precursors During the Pyrolysis of Shenmu Coal

Experimental Investigation on N2 Formation During Pyrolysis of Fushun Coal

Nitrogen Conversion During Rapid Pyrolysis of Coal and Petroleum Coke in a High-Frequency Furnace

High-temperature pyrolysis behavior of two different rank coals in fixed-bed and drop tube furnace reactors