Abstract:Three-dimensional (3-D) photonic bandgap (PBG) structures were fabricated by laser chemical vapor deposition (LCVD) of silicon among self-assembled silica particles on silicon substrates. The multilayer self-assembly of colloidal silica particles were formed on silicon substrates using isothermal heating evaporation approach. A Nd:YAG laser (1064 nm wavelength) was used as the energy source for LCVD processing. A silica-silicon shell PBG structure was obtained. By removing silica particles embedded in the silicon using hydrofluoric acid, another air-silicon shell PBG was produced. This technique is capable of fabricating the complete PBG, which is predicted by theoretical calculations with the plan-wave method. This might enable us to engineer the position of PBG by flexibly varying the silica particle size. Ellipsometry was used to identify specific bandgaps at various crystal directions for both structures. The transmission matrix method is used to simulate the transmission spectra of the structures, which agree with the experimental results.Three-dimensional (3-D) photonic bandgap (PBG) structures were fabricated by laser chemical vapor deposition (LCVD) of silicon among self-assembled silica particles on silicon substrates. The multilayer self-assembly of colloidal silica particles were formed on silicon substrates using isothermal heating evaporation approach. A Nd:YAG laser (1064 nm wavelength) was used as the energy source for LCVD processing. A silica-silicon shell PBG structure was obtained. By removing silica particles embedded in the silicon using hydrofluoric acid, another air-silicon shell PBG was produced. This technique is capable of fabricating the complete PBG, which is predicted by theoretical calculations with the plan-wave method. This might enable us to engineer the position of PBG by flexibly varying the silica particle size. Ellipsometry was used to identify specific bandgaps at various crystal directions for both structures. The transmission matrix method is used to simulate the transmission spectra of the structures, wh...

Development of 3D ceramic photonic bandgap structures

Fabrication of 3-Dimentional Photonic Band Gap Materials by Micromolding Method and Optical Properties Measurement

Fabrication, characterization and simulation of noval 3-D photonic bandgap structures using laser chemical vapor deposition

Creation of Partial Band Gaps in Anisotropic Photonic-Band-gap Structures

Bandpass Waveguide in 3D Diamond‐structure EBG Fabricated by Stereolithography and Gel Casting

Fabrication of Photonic Bandgap Materials by Shifting Double Frameworks.

Printing of 3D photonic crystals in titania with complete bandgap across the visible spectrum

Effective fabrication method of 3D ceramic photonic crystals with diamond structure

Stealthy and hyperuniform isotropic photonic bandgap structure in 3D

Three-dimensional Electromagnetic Band-Gap Structure Containing TiO 2 Fabricated by Rapid-Prototyping

Photonic Bandgap of Gradient Quasidiamond Lattice Photonic Crystal

Improvement of the Photonic Bandgap in Three-Dimensional Diamond Lattice Microstructures Obtained by Two-Photon Polymerization

Microwave Absorption in Photonic Crystals Composed of SiC/Resin with a Diamond Structure

Microwave Bandgap in Multilayer Ceramic Structures

Fabrication of Diamond‐structured Multiceramic Coupling Photonic Crystal and Its Ultra‐wide Bandgap Properties

Characteristics Modeling of Photonic Crystal by Using Numerical Techniques

High-quality photonic crystals with a nearly complete band gap obtained by direct inversion of woodpile templates with titanium dioxide

Fabrication of three-dimensional electromagnetic band-gap structure with high-K dielectric ceramics by rapid-prototyping

Stealthy and hyperuniform isotropic photonic band gap structure in 3D

Novel 1-D Sandwich Photonic Bandgap Structure

Experimental probe of a complete 3D photonic band gap