Abstract:This work presents a low-power high-speed system-on-chip (SoC) for wireless body area networks (WBANs). The SoC is fully integrated with a 10 Mb/s on-off keying (OOK) RF transceiver, digital processing units, an 8051 micro-controlled unit (MCU), a successive approximation (SAR) ADC, and etc. The receiver adopts envelop detector (ED) based structure to improve the energy efficiency. Conventional ED based structure has a poor sensitivity when reaching a bit rate of Mb/s level. To resolve the problem, we design a receiving (Rx) front-end with 77 dB gain at 10 Mb/s data rate, and propose a novel supply isolation scheme to avoid the instability induced by such a high gain. The transmitter is based on a 2 GHz digitally controlled oscillator (DCO), which uses bond wires as inductors to further reduce the power at transmitting (Tx) mode. The digital baseband is designed by a near-threshold design (NTD) method for low power consumption. The chip is implemented with 0.13 μm CMOS technology, measured results show that the receiver consumes 0.214 nJ/bit at -65 dBm sensitivity, and the Tx energy efficiency is 0.285 nJ/bit at an output power of -5.4 dBm. In addition, the digital baseband consumes 34.8 pJ/bit with its supply voltage lowered to 0.55 V, indicating its energy per bit is reduced to nearly 1/4 of the super-threshold operation.

The design of an IEEE 802.11b baseband processor with reduced hardware complexity

The design of 802.11b WLAN baseband processor

A compact dual-band direct-conversion CMOS transceiver for 802.11a/b/g WLAN

A Low Power Sub-GHz PLL with Optimized Class-C Voltage-controlled Oscillator

A ${\hbox{70}}{\hbox{–}} {\Hbox{78-}}{\Hbox{ghz}}$ Integrated CMOS Frequency Synthesizer for $W$-Band Satellite Communications

An ultra low-power and area-efficient baseband processor for WBAN transmitter.

An Ultra Low Power Baseband Transceiver IC for Wireless Body Area Network in 0.18- \mu M CMOS Technology

Efficient demodulation circuit design for IEEE802.15.4

Design of a low-cost low-power baseband-processor for UHF RFID tag with asynchronous design technique

A 0.65μW baseband processor for UHF RFID with on-chip antenna

Novel baseband processor for ultra-low-power passive UHF RFID transponder

A Baseband Transceiver for Multi-Mode and Multi-Band SoC.

Design and Implementation of Baseband-processor for ZigBee Network Node

Design of A Digital Baseband Processor for Uwb Transceiver on Rfid Tag

Design of a Software-Defined Transceiver with High Flexibility for Sensing Applications

A Low Voltage CMOS RF Front-End for IEEE 802.11b WLAN Transceiver

A 2.4-Ghz Fully CMOS Integrated Transmitter for 802.1lb Wireless LAN

Design of an UHF RFID Interrogator Baseband Processor

An Energy Efficient Fully Integrated OOK Transceiver SoC for Wireless Body Area Networks

A 0.18 Um Cmos Reconfigurable Digital Baseband Transceiver With 2fsk For Rfid

An Asynchronous Design Method and Its Application on a Low-Power RFID Baseband Processor