Abstract:In order to directly observe the conversion between guided-wave modes and leaky-wave modes in a periodic structure, quadrilateral periodic metal diaphragms arranged in two ways on metal surfaces were analyzed. In the first scheme, each unit cell in the periodic structure contains a metal diaphragm, of which the dispersion characteristics of periodic structures were analyzed by the finite element method. The results of the numerical simulation show that by adjusting lattice constants of periodic structures and geometrical parameters of metal diaphragms, the transmission bandwidth of the present 1-D periodic metal diaphragm structures could be limited to X-band, where the transmission characteristics are easy to be measured. In the second scheme, a pair of mirror-symmetric and staggered quadrilateral metal diaphragms is introduced into a unit cell. It can be found in the theoretical calculation that a new dispersion curve, which passes through the light line in a high frequency range, can be exhibited. The propagation constants of dispersion curves become complex numbers and provide highly directional electromagnetic radiation that scans as the frequency changes. After the relative positions of the two metal diaphragms were properly adjusted, the frequency range of the forbidden band gap between two dispersion curves can be minimized, so as to increase the transmission bandwidth of the 1-D periodic metal structures. The experimentally measured results show that the dispersion curves of the two periodic structures were highly consistent with the theoretical results. The narrowing of the band gap could be verified by measuring the $S$ -parameters. The near-field measurement of the periodic metal structures can demonstrate the conversion between the guided-wave modes and the leaky-wave modes, and the far-field measurement can show the frequency dependence of beam elevation. We expect that these artificial material structures could be widely used for designing new microwave and terahertz band devices.

Metal-coated long period gratings for detection of corrosion

&Lt;title>effects of Metal-Cladding on the Cutoff Condition of Optical Waveguides</title>

A Direct Near-Field Observation of Conversion Between Waveguide Modes and Leaky Modes in Periodic Metal Structures

Thick Metal Coating Long-Period Fiber Grating

Metal Coatings on Long-Period Fiber Gratings and the Implementation of an Associated Sensing Model

Monitoring Passivation, Pitting Corrosion Initiation, and Propagation of Steel Bar with Iron–Carbon Electroplated Long Period Fiber-Grating Sensor

Enhanced Optical Transmission Through Metal-Dielectric Multilayer Gratings

Small period long period grating with enhanced sensitivity in low refractive index region

Long-period Grating Fabricated by Periodically Tapering Standard Single-Mode Fiber.

Long-period grating and its cascaded counterpart in photonic crystal fiber for gas phase measurement

Long-period Grating Fabricated Using Resistive Filament Heating

Numerical Analysis of Coupling from Core Mode to Radiation Mode in Long Period Fiber Gratings

The Long-Period Fiber Grating Coated with Langmuir-Blodgett Thin Film for Applications on Biochemistry Sensors

Simulation Method for Analyzing Mechanical Long-Period Fiber Gratings under High Birefringence

CO2 laser-written long-period fiber grating with a high diffractive order cladding mode near the turning point

Mode-Coupling and Propagation in a Deeply-Tapered Few-Period Long-Period Fiber Grating

Line by line inscribed small period long period grating for wide range refractive index sensing

Study of Sensing Properties and Contrastive Analysis of Metal Coating Optical Fiber Grating

Numerical Study on the Optical Absorption of One Dimension Metallic Gratings

Fabrication of A Compact Reflective Long-Period Grating Sensor with A Cladding-Mode-Selective Fiber End-Face Mirror

Comparison Study of Optical Sensing Property of Gratings with and Without Lamellae Layers