Abstract:In the design study of large-sized sodium-cooled fast reactors in Japan (JSFR), the suppression of gas entrainment (GE) phenomena at a free surface in the reactor vessel is very important to establish an economically superior design. However, the GE phenomena are highly non-linear and too difficult to be evaluated theoretically. Therefore, we are developing high-precision CFD method for gas-liquid two-phase flows to evaluate the GE phenomena accurately. To reproduce the GE phenomena by CFDs, there are three key issues, i.e. geometry dependency, interfacial dynamics and locality. Former two issues are already addressed by employing unstructured mesh schemes and a high-precision simulation method for gas-liquid two-phase flow based on the PLIC (Piecewise Linear Interface Calculation) method, respectively. In fact, the simulation results of the GE phenomena in a simple GE experiment showed good agreements with experimental data. Recently, therefore, we focus on the locality of the GE phenomena. In our previous study (presented in ICONE17), the two-dimensional unstructured adaptive mesh technique for single-phase flows was developed to address the third issue. The isotropic cell refinement method was employed and the connection cell method was proposed to eliminate the edge incompatibility. The verification/validation results showed that the developed unstructured adaptive mesh technique succeeded in providing a high-precision solution, even though a poor-quality distorted mesh at the initial state was employed. In this study, the unstructured adaptive mesh technique is extended to the numerical simulations of gas-liquid two-phase flows. The redistribution methods of two-phase flow variables are newly developed to satisfy the conservations of the variables, i.e. the volumes of gas and liquid phases, the location of interfaces and the momentum of each phase. This improved unstructured adaptive mesh technique for gas-liquid two-phase flows is validated by solving the well-known slotted disk revolution and dam-break problems. As a result, the unstructured adaptive mesh technique succeeds in maintaining the slotted-disk shape after one revolution and shows more than first order accuracy (grid convergence) in the slotted-disk revolution problem. In addition, thanks to the momentum-conservative formulation, the dam-break phenomenon is well simulated by the unstructured adaptive mesh technique. Especially, wave-breaking phenomena are simulated by refined cells near the gasliquid interface. It should be noted that these simulation results are obtained by using relatively small number of cells because of the efficient mesh adaptation by the unstructured adaptive mesh technique.

Particle methods to analyze complex two-phase flow in nuclear reactors

3521 Detailed Analysis of Multi-phase Flow in Nuclear Reactor Cores Using a Particle Method

Inflow and Outflow Numerical Simulation Using Least-Square Moving Particle Semi-Implicit Method on GPU

Improvement of Pressure Calculations in the Moving Particle Semi-Implicit Method for Free-Surface Flows

Simulation of Isothermal Multi-Phase Fuel-Coolant Interaction Using MPS Method with GPU Acceleration

Analysis of Subcooled Boiling with the Two-Fluid Particle Interaction Method

A stable moving particle semi-implicit method

Material Point Method and Smoothed Particle Hydrodynamics Simulations of Fluid Flow Problems: a Comparative Study

Nanoparticle-laden Flows Via Moment Method: A Review

A Conservative Finite Volume-Particle Hybrid Method for Simulation of Incompressible Interfacial Flow

Dissipative Particle Dynamics and other particle methods for multiphase fluid flow in fractured and porous media

THE DYNAMICS OF NANOPARITCLE—LADEN MULTIPHASE FLOW AND ITS APPLICATIONS

Unstructured Adaptive Mesh Technique for Gas-Liquid Two-Phase Flows

An improved MPS method for simulating multiphase flows characterized by high-density ratios and violent deformation of interface

Unified Gas-Kinetic Wave–particle Method for Gas–particle Two-Phase Flow from Dilute to Dense Solid Particle Limit

Recent Progress on Mesh-free Particle Methods for Simulations of Multi-phase Flows: A Review

Improvement of solidification model and analysis of 3D channel blockage with MPS method

A Finite Particle Method with Particle Shifting Technique for Modeling Particulate Flows with Thermal Convection

Modified Particle Method with Integral Navier-Stokes Formulation for Incompressible Flows

An Advanced Moving Particle Semi-Implicit Method for Accurate and Stable Simulation of Incompressible Flows

Improved Moving Particle Semi-implicit method for multiphase flow with discontinuity