Abstract:The prevalence of concrete-filled steel tubular (CFST) catenary arches, renowned for the optimal load-bearing efficiency, has shown a marked increase over the past decades. To date, extensive research has been conducted into the nonlinear buckling behaviors and elastic-plastic strength of circular and parabolic CFST arches, grounded on the assumption that the curvature of the arch axis remains a specific constant. However, for CFST catenary arches, this assumption is not appropriate, given the substantial variation in curvature along the arch rib, and the influence of the arch axis is not adequately addressed in the existing design codes. Therefore, in this paper, a more precise strain expression is employed to conduct the nonlinear buckling analysis on CFST catenary arches. The analytic solutions for both symmetric snap-through buckling and anti-symmetric bifurcation buckling loads are obtained. In addition, a validated finite element (FE) model is adopted to investigate the influence of key parameters, including the slenderness ratio , the arch-axis coefficient, the rise-to-span ratio, and the steel ratio, on the in-plane stability bearing capacity of CFST catenary arches subjected to axial compression. Moreover, the obtained numerical results are utilized for comparison with the prediction results calculated by the existing design codes for CFST or steel arches. The comparison results indicate that the existing design codes have tended to overestimate the in-plane strength of CFST catenary arches, mainly due to the ignorance of the influence of pre-buckling deformation. Thus, based on the nonlinear buckling analysis results, a revised lower-bound design formula for predicting the in-plane stability bearing capacity of CFST catenary arches under axial compression is proposed, considering the influence of the rise-to-span ratio and the steel ratio.

Nonlinear Finite Element Analysis of Concrete Filled Steel Tubular (Single Tube) Arch Subjected to Spatial Loads

Numerical Analysis of Ultimate Strength of Concrete Filled Steel Tubular Arch Bridges

Finite-element Analysis for Nonlinear Stabilities of Concrete-filled Steel Tubular Arch Bridges

Approach for Analyzing the Ultimate Strength of Concrete Filled Steel Tubular Arch Bridges with Stiffening Girder

Parametric Study of In-Plane Ultimate Bearing Capacity of CFST Truss Rib Arch Bridge

In-Plane Nonlinear Buckling Analysis of Deep Circular Arches Incorporating Transverse Stresses

EXPERIMENTAL INVESTIGATION AND NONLINEAR FINITE ELEMENT ANALYSIS ON THE BEHAVIOR OF CONCRETE-FILLED SQUARE STEEL TUBULAR COLUMN CONNECTIONS

Nonlinear Finite Element Modeling of Concrete-Filled Circular Frp Arch Tubes under Monotonic Loading

In-plane nonlinear buckling analysis and design method of concrete-filled steel tubular catenary arches

In-plane nonlinearity stability strength of circular concrete-filled steel tubular arches

Material Nonlinearity Analysis of Steel Tube Concrete Arch

Nonlinear Finite Element Analysis on Mechanical Performance of Concrete Filled Steel Tubular Frame Structure

Nonlinear Finite Element Analysis of Multi-Story Concrete-Filled Steel Tubular Frame Based on Three-Dimension Element

Investigating the Hysteretic Behavior of Concrete-Filled Steel Tube Arch by Using A Fiber Beam Element

Time-Dependent Analysis of Long-Span, Concrete-Filled Steel Tubular Arch Bridges

Finite Element Analysis On Load-Bearing Behavior Of Concrete Filled Steel Tubular Composite Framese

In-plane strength of concrete-filled steel tubular circular arches

Experimental Investigation into In-plane Stability of Concrete-Filled Steel Tubular Parabolic Arches under Five-Point Concentrated Loads

Nonlinear finite element analysis of axially loaded concrete-filled steel tubular stub columns

Non-linear Torsion Behaviour of Concrete Filled Steel Tube Columns

Investigation On Single Tube Cfst Arch Models By Modeling Structural Stressing State Based On Nsf Method