Abstract:Long-term, continuous in-situ observation of seabed deformation plays an important role in studying the mechanisms of sand wave migration and engineering early warning methods. Research on pressure sensing techniques has examined the possibility of using the temporal characteristics of the vertical deformation of the seafloor to identify important factors (e.g., wave height and migration rate) of submarine sand wave migration. Two pressure sensing tools were developed in this study to observe the seabed deformation caused by submarine sand wave migration (a fixed-depth total pressure recorder (TPRFD) and a surface synchronous bottom pressure recorder (BPRSS)), based on the principle that as a sand wave migrates under hydrodynamic forcing, the near-bottom water pressure, bottom pressure and total fixed pressure synchronously change with time. Laboratory flume experiments were performed, using natural sandy sediments taken from the beach of Qingdao, China, to better present and discuss the feasibility and limitations of using these two pressure sensing methods to acquire continuous observations of seabed deformation. The results illustrate that the proposed pressure sensor techniques can be effectively applied in reflecting elevation caused by submarine sand wave migration (the accuracy of the two methods in observing the experimental bed morphology was more than 90%). However, an unexpected step-like process of the change in sand wave height observed by BPRSS is presented to show that the sensor states can be easily disturbed by submarine environments, and thus throw the validity of BPRSS into question. Therefore, the TPRFD technique is more worthy of further study for observing submarine sand wave migration continuously and in real-time.

In-situ monitoring and assessment techniques for pore pressure of seabed soil

Research on Measurement and Control System of Deep-Sea Self-Contained Static Cone Penetration Probe

Experimental investigation on wave-induced response of seabed

Design and Application of a Deep-Sea Engineering Geology In Situ Test System

Pore Pressure Observation: Pressure Response of Probe Penetration and Tides

IN-SITU MONITORING OF SEABED SEDIMENTS CONSOLIDATION PROCESS IN YELLOW RIVER ESTUARY BY ELECTRICAL RESISTIVITY METHOD

Pressure Sensing Technique for Observing Seabed Deformation Caused by Submarine Sand Wave Migration

Experimental Investigation on the Wave-Induced Pore Pressure Around Shallowly Embedded Pipelines

Field Observation of the Wave-Induced Pore Pressure Response in a Silty Soil Seabed

Development of an Underwater Adaptive Penetration System for In Situ Monitoring of Marine Engineering Geology

A New Method for Long-Term in Situ Monitoring of Seabed Interface Evolution: A Self-Potential Probe

Assessment of Seabed Trench Formation Based on Marine Sediment Properties and Chain-Bar Penetration Tests

Experimental Study for Wave-Induced Oscillatory Pore Pressures in A Sandy Seabed

In Situ Experiment of Wave-Induced Excess Pore Pressure in the Seabed Sediment in Yellow River Estuary

Characterization of spatio-temporal distributions of wave-induced pore pressure in a non-cohesive seabed: Amplitude-attenuation and phase-lag

Research on In-Situ Observation System of Seabed Boundary Layer Based on Self-Potential Measurement

Pore Pressure Response of Seabed in Standing Waves and Its Mechanism

Applicability of Equipment Based on FBG Sensors for Excess Pore Pressure Monitoring in Deep Seabed

An Analytical Solution For Wave-Induced Soil Response And Seabed Liquefaction

Excess Pore Pressure Observation in Marine Sediment Based on Fiber Bragg Grating Pressure Sensor

An Experimental Study of Seabed Responses Around a Marine Pipeline under Wave and Current Conditions