Abstract:This study harnessed bivariate correlational analysis, multiple linear regression analysis and tree-based regression analysis to examine the relationship between laser process parameters and the final material properties (bulk density, saturation magnetization (M s ), and coercivity (H c )) of Fe-based nano-crystalline alloys fabricated via laser powder bed fusion (LPBF). A dataset comprising of 162 experimental data points served as the foundation for the investigation. Each data point encompassed five independent variables: laser power (P), laser scan speed (v), hatch spacing (h), layer thickness (t), and energy density (E), along with three dependent variables: bulk density, M s , and H c . The bivariate correlational analysis unveiled that bulk density exhibited a significant correlation with P, v, h, and E, whereas M s and H c displayed significant correlations exclusively with v and P, respectively. This divergence may stem from the strong influence of microstructure on magnetic properties, which can be impacted not only by the laser process parameters explored in this study but also by other factors such as oxygen levels within the build chamber. Furthermore, our statistical analysis revealed that bulk density increased with rising P, h, and E, while decreased with higher v. Regarding the magnetic properties, a high M s was achievable through low v, while low H c resulted from high P. It was concluded that P and v were considered as the primary laser process parameters, influencing h and t due to their control over the melt-pool size. The application of multiple linear regression analysis allowed the prediction of the bulk density by using both laser process parameters and energy density. This approach offered a valuable alternative to time-consuming and costly trial-and-error experiments, yielding a low error of less than 1 % between the mean predicted and experimental values. Although a slightly higher error of approximately 6 % was observed for M s , a clear association was established between M s and v, with lower v values corresponding to higher M s values. Additionally, a further comparison was conducted between multiple linear regression and three tree-based regression models to explore the effectiveness of these approaches.

A Fusion Prediction Model Based on Regression and Neural Network for Nano-composite NdFeB Permanent Magnet Alloy

Application of magnetic materials oriented knowledge management

Prediction Model for Megnetic Properties of Nd-Fe-Co-Zr-B Alloys Based on Artificial Neural Network

Investigation of Optimal Megnetic Properties in NdFeB Magnets by Artificial Neural Network

Study for Effect of Alloying Element on Megnetic Properties of NdFeB Magnets by Artificial Neural Network

Prediction of Hard Magnetic Properties for Melt-Spun Nd2Fe14B and Nd2Fe14B/Fe3B Based on Machine Learning

An Improved Neural Network Model for Prediction of Mechanical Properties of Magnesium Alloys

Prediction of amorphous forming ability based on artificial neural network and convolutional neural network

Improvement and Application of Neural Network Models in Development of Wrought Magnesium Alloys

Prediction Model of Copper Matte Grade Based on Intelligent Fusion Strategy

Research on the Formation Mechanism of MgO and Al2O3 on Composite Calcium Ferrite Based on DA-RBF Neural Network

Nonlinear Combination Neural Network Model of Intelligent Prediction on Electrode Properties

A Hybrid Knowledge-Based Neural-Fuzzy Network Model with Application to Alloy Property Prediction

A prediction model based on neural network and fuzzy Markov chain

Image-based prediction and optimization of hysteresis properties of nanocrystalline permanent magnets using deep learning

Construction of a Machine-Learning-based Prediction Model for Mechanical Properties of Ultra-Fine-grained Fe–C Alloy

A Predictive Modeling for Blast Furnace by Integrating Neural Network with Partial Least Squares Regression

A Novel Physically Guided Data Fusion Prediction Model for Micro-EDM Drilling

A Trend Prediction Method Based on Fusion Model and Its Application

Analysis of Magnetic Properties of AlNiCo and Magnetization State Estimation in Variable-Flux PMSMs

Predictive modelling of laser powder bed fusion of Fe-based nanocrystalline alloys based on experimental data using multiple linear regression analysis