Abstract:Three H-Oil gas oils, heavy atmospheric gas oil (HAGO), light vacuum gas oil (LVGO), heavy vacuum gas oil (HVGO), and two their blends with hydrotreated straight run vacuum gas oils (HTSRVGOs) were cracked on two high unit cell size (UCS) lower porosity commercial catalysts and two low UCS higher porosity commercial catalysts. The cracking experiments were performed in an advanced cracking evaluation fluid catalytic cracking (FCC) laboratory unit at 527 °C, 30 s catalyst time on stream, and catalyst-to-oil (CTO) variation between 3.5 and 7.5 wt/wt The two high UCS lower porosity catalysts were more active and more coke selective. However, the difference between conversion of the more active high UCS lower porosity and low UCS higher porosity catalysts at 7.5 wt/wt CTO decreased in the order 10% (HAGO) > 9% (LVGO) > 6% (HVGO) > 4% (80% HTSRVGO/20% H-Oil VGO). Therefore, the catalyst performance is feedstock-dependent. The four studied catalysts along with a blend of one of them with 2% ZSM-5 were examined in a commercially revamped UOP FCC VSS unit. The lower UCS higher porosity catalysts exhibited operation at a higher CTO ratio achieving a similar conversion level with more active higher UCS lower porosity catalysts. However, the higher UCS lower porosity catalysts made 0.67% Δ coke that was higher than the maximum acceptable limit of 0.64% for this particular commercial FCC unit (FCCU), which required excluding the HVGO from the FCC feed blend. The catalyst system containing ZSM-5 increased the LPG yield but did not have an impact on gasoline octane. It was found that the predominant factor that controls refinery profitability related to the FCCU performance is the FCC slurry oil (bottoms) yield.This article has not yet been cited by other publications.

Catalytic Conversion of FCC Gasoline in A Dower Reactor

Study of Fluid Catalytic Cracking Process in Experimental Downer Reactor

Downer-to-riser coupling technique for heavy oil catalytic cracking

Experimental Study of the Deep Catalytic Cracking Process in a Downer Reactor

Downer-to-Riser Coupling Technique for Petroleum Refining

Study on the FCC process of a novel riser-downer coupling reactor (III): Industrial trial and-CFD modeling

Catalytic Mechanism of MCM-41 Supported Phosphoric Acid Catalyst for FCC Gasoline Desulfurization by Alkylation: Experimental and Theoretical Investigation

Reactive Adsorption Desulfurization Coupling Olefin Conversion in Fluid Catalytic Cracking Gasoline Upgrading Process

Design and control of fluid catalytic cracking gasoline fractionator

HEAVY OIL DEEP CATALYTIC CRACKING PROCESS IN DOWNER REACTOR TO PRODUCE LIGHT OLEFINS

Understanding Riser and Downer Based Fluid Catalytic Cracking Processes by A Comprehensive Two-Dimensional Reactor Model

Coupling Conversion of CO2 and High‐carbon Alkane to CO and Gasoline

Modeling of the Riser-Downer-Coupling Reactor

Coker Gasoline As a Hydrogen Donor for FCC

CFD–DEM Simulation of Gas–solid Reacting Flows in Fluid Catalytic Cracking (FCC) Process

Molecular level analysis on performance of diameter expanding reactor to improve gasoline quality in FCC process

Role of Catalyst in Optimizing Fluid Catalytic Cracking Performance During Cracking of H-Oil-Derived Gas Oils

Cracking Performance of Gasoline and Diesel Fractions from Catalytic Pyrolysis of Heavy Gas Oil Derived from Canadian Synthetic Crude Oil

An Insight into Effect of Methanol on Catalytic Behavior of Amberlyst 35 Resins for Alkylation Desulfurization of Fluid Catalytic Cracking Gasoline

A Dispersion Model for Fluid Catalytic Cracking Riser and Downer Reactors

Simulation Analysis of Gas-Solid Two-Phase Flow and Reaction in a Novel Catalytic Cracking Reactor