Abstract:The effectiveness of tunnel monitoring is a challenging task due to the limitations of monitoring gauges and lack of monitoring sections. To address this, a novel theoretical analysis-based monitoring method for tunnel structures was proposed in this study. A theoretical approach was employed to establish the correlation between external loads and structural stress–strain response in tunnel lining during grouting and stability periods. A method has been developed to derive the distribution of external loads and internal forces throughout the entire tunnel using strain monitoring at specific locations on the structure. This method has been further validated through a case study of the Liucun Tunnel, providing insights into the accuracy of the monitoring approach. It is found that during the grouting period, the segment ring is surrounded by grout, resulting in peak external loads and internal forces. As the tunnel lining enters the load stability period, both the external loads and internal forces gradually decrease and stabilize. Comparing the results of the monitored method for deriving tunnel external loads, structural bending moments and axial forces with the on-situ measurements, the new monitoring method yields errors in the response of tunnel external loads and internal forces. The average error in external loads is less than 12%, the average error in bending moments is less than 20%, and the average error in axial forces is less than 8%. The proposed monitoring method effectively addresses the issue of long-term failure of monitoring elements due to its replaceability. Additionally, utilizing theoretical methods for derivation allows obtaining more tunnel structural information based on limited monitoring data from the elements. This provides a new approach for long-term structural health monitoring. To address the existing errors in the monitoring method described in this study, the accuracy can be further improved by optimizing the model, incorporating more advanced monitoring techniques, and implementing standardized and improved construction practices.

STUDY ON MONITORING AND BACK ANALYSIS FOR ROAD TUNNEL WITH COMPLEX GEOLOGY

SITE MONITORING AND ANALYSIS OF NON-SYMMETRICAL MULTI-ARCH HIGHWAY TUNNEL

Monitoring and Survey of Tunnel NATM on the Yuxiang Highway

Application of monitoring measurement technology in Qiaozhuang tunnel

Monitoring and Numerical Simulation on the Deformation of Sheng-hong-qing Tunnel

Dynamic Monitoring and Numerical Simulation Analysis of Closely-spaced Tunnel

Analysis of Monitoring and Measurement of Small Clear Spacing Tunnel in the Excavation by NATM

In-situ Monitoring and Mechanical Analysis of Large-Span Unsymmetrical Loading Multi-Arch Tunnel

COMPREHENSIVE STUDY ON PREDICTION OF ROCKBURST IN DEEP AND OVER-LENGTH HIGHWAY TUNNEL

Monitoring and Analysis of Xintangfang Tunnel Construction

Study on structural mechanical characteristics and safety warning of NATM tunnel in aquifer

STUDY ON SITE MONITORING OF LARGE-SECTION HIGHWAY TUNNELS WITH SMALL CLEAR SPACING

Monitoring and Back Analysis of Displacement of Jing-zhu Expressway Wenquan Tunnel

MECHANISM ANALYSIS AND MONITORING FORECAST OF LANDSLIDE AT ROAD TUNNEL FACE

Site Monitoring and Information Feedback of Highway Tunnel

On application research on monitoring measurement in Fengxiangya tunnel

Dynamic Monitoring and Numerical Simulation of Tunnel under Difficult Ground Condition

A tunnel structure health monitoring method based on surface strain monitoring

3D MONITORING AND ANALYSIS OF LANDSLIDE DEFORMATION CAUSED BY TWIN-ARCH TUNNEL

Monitoring Deformation Behavior of Shallow Buried Large-span Tunnel in Gravel Deposits During Excavation and Its Analysis

STABILITY ANALYSIS AND MONITORING FOR TUNNEL IN LOOSE SOILS DURING CONSTRUCTION