Fabrication and principle of platelet-rich plasma in the the repair of bone and soft tissues
袁霆,张长青
DOI: https://doi.org/10.3321/j.issn:1673-8225.2004.35.031
2004-01-01
Abstract:Aim: The platelet-rich plasma(PRP) contains various high-concentration growth factor, and it can promote the bone healing and repair of soft tissues. The aim of this paper is to investigate the principle of making PRP with centrifuging in order to provide an experimental basis for repairing the tissue defect with PRP in clinical application. Methods: From the antecubital veins, 5 mL, blood was drawn. Four methods with different centrifugal times, force and time were selected to make PRP, all the PRP were 0.7 mL. The count and activation rate of platelet in all kinds of PRP and the whole blood were measured in comparison. Results: The mean platelet count in whole blood was 214.41 × 109 L-1, significantly lower than that in all the PRP productions made by different ways. Platelet counts in PRP were 629. 95 × 109 L-1 (Anitua method), 1 093.00 × 109 L-1 (Petrungaro method), 1 323. 80 × 109 L-1(Landesbergo method). 1 347.05 × 109 L-1(Aghaloo method), respectively, which were 2.92, 5.10, 6.17 and 6.28 times of the platelet count. The platelet count in PRP and the platelet count in whole blood were in positive correlation, and the correlation coefficients were rAnitua = 0.79, rPetrungaro = 0.83, rLandesberg = 0.93 and rAghaloo = 0.89, respectively. The expression of CD62P in whole blood was 0.85%, and 4.87% (Anitua), 9.79% (Petrungaro), 6.05% (Landesberg) and 9.12% (aghaloo) by activation detect. There were significant differences in the expressional rate of CD62P between whole blood and PRP, and among PRPs as well. Conclusion: Concentration and recovery rate of platelet in PRP after twice centrifugation are higher than that after once centrifugation. Landesberg method of making PRP is a better one in comparison with other methods, which can produce higher concentration of platelet and lower rate of activation.
What problem does this paper attempt to address?