Abstract:This paper aims to introduce an optimised design method for electric actuators based on the principles of the TPMLM using Halbach arrays. A surrogate model is built from the subdomain model. A multi‐objective optimisation method considering machining and assembly errors is established by employing the interval possibility and the interval order theory which significantly improves the overall performance of the electric actuator. To the challenges posed by the complex structure and low reliability of existing hydraulic actuators used for more electric aircraft landing gear, this paper proposes an optimised design method for an electric actuator based on the principles of tubular permanent magnet linear motor employing a Halbach array. For this electric actuator, a subdomain model considering the longitudinal end effect is established by setting virtual permanent magnet regions at both ends of the Halbach array. The effectiveness of the proposed method is verified through a comparison with the finite element method. Subsequently, a surrogate model is developed using the proposed subdomain model, and an uncertain optimisation model considering machining and assembly errors is developed based on the interval possibility and the interval order theory. Compared to its initial design, the optimised structure increased the average thrust by 13.4% and reduced the thrust ripple rate by 87.2%, significantly improving the overall performance of the electric actuator. Finally, prototype experiments are carried out to verify the effectiveness of the proposed subdomain method and optimised approach.

On Exploring Suitable Micro-Actuator for Aerodynamic Control of Delta Wing

Application of Iterative Learning Tuning to a Dragonfly-Like Flapping Wing Micro Aerial Vehicle

A Study on Cylindrical Type of MR Fluid Actuator

Numerical Investigation by Applying Microballoon Actuators on High-Altitude Propeller

Dynamics of A Rotor Supported on Magnet-Rheological Fluid Squeeze Film Damper

A New X-Actuator Design for Controlling Wing Bending and Twisting Modes

A NEW X-ACTUATOR DESIGN FOR DUAL BENDING/TWISTING CONTROL OF WINGS

An Experimental Study into Dynamic Behavior of a Magnetorheological Fluid Squeeze Film Damper – Overhung Flexible Rotor

Aerodynamic Simulation of a Typical Multirotor e VTOL Aircraft Configuration.

Airfoil Roll Control by Bang-Bang Optimal Control Method with Plasma Actuators

Combination of Advanced Actuator Line/Disk Model and High-Order Unstructured Finite Volume Solver for Helicopter Rotors

Experimental Validation of an Effective Control Mechanism to Enable Flapping Wing Rotor Stable Flight

Design of a magnetically actuated flapping wing contrivance

Research on Optimization of Stable Damper for Passive Stabilized Double-wing Flapping Micro Air Vehicle

Feedback and Control of Linear Electromagnetic Actuators for Flapping Wing MAVs

Three-Dimensional Simulation of Micro Air Vehicles with Low-Aspect-Ratio Wings

Micro Plasma Actuator Location Effect on Complex Fluidic Behavior: An Optimization Study

Design and experimental study of a new flapping wing rotor micro aerial vehicle

Optimal Selection of Active Jet Parameters for a Ducted Tail Wing Aimed at Improving Aerodynamic Performance

Optimised design of electric actuators for more electric aircraft considering machining and assembly errors

Modelling, attitude controller design and flight experiments of a novel micro-ducted-fan aircraft