Study of workability limits of porous materials under different upsetting conditions by compressible rigid plastic finite element method
X. Q. Zhang,Y. H. Peng,X. Y. Ruan,M. Q. Li,S. C. Wu
DOI: https://doi.org/10.1361/105994900770346114
IF: 2.3
2000-01-01
Journal of Materials Engineering and Performance
Abstract:Workability limits must be considered when designing powder metallurgy (PM) forging processes. This research successfully applied the general upsetting experiment method to the deformation of porous materials. Based on the plastic theory of porous materials, the compressible rigid plastic finite element method is used to simulate the deformation processes of cold upsetting of disks and rings for porous metal materials with a full account of contact friction boundary conditions, the height-to-diameter ratio, the initial relative density, and the die and workpiece geometry. Furthermore, a successful analysis of the cold forging process results in the prediction of the stress, the strain, and the density field. By coupling with the ductile fracture criterion, which is a strain-based criterion obtained by Lee and Kuhn, possible defects leading to material failure have been checked. This research reveals that larger height to diameter and a lesser friction factor can delay the local strain locus to intersect with the Lee and Kuhn’s fracture line and restrain formation of the surface crack. Meanwhile, it reveals that the initial relative density has only a very small influence on the strain to fracture in compression, and it shows the forming behavior of the ring and disk with the curved die. According to Lee and Kuhn’s results, the calculated results agree well with the experimental results.