Abstract:The paper addresses the method for stator and rotor resistance identification in speed sensorless induction motor drives. The instability problem caused by pure integration of the voltage model (VM) of rotor flux is handled by introducing correction terms in the VM. It is, however, shown that the third-order persistent excitation (PE) condition for simultaneous identification of stator, rotor resistances and rotor speed can barely be satisfied even with extra excitations in rotor flux modulus command. And an adaptive observer that is not persistently excited may become instable when exposed to bounded disturbances. Hence, to design a robust flux observer, concept of time-division multiplexing is incorporated into the observer design. That is, stator resistance is identified as the flux modulus is flat, while rotor resistance is adapted as a ramp flux modulus command is applied. This relaxes PE condition to order two, and as a drawback, the ramp flux modulus command incurs speed ripples. The decoupled identifiability of stator resistance is designed and explained, a rigorous input-to-state stability analysis of both the mismatch [between VM and current model (CM)] and the error (between actual rotor flux and CM) is set forth, and a convergence analysis of parameters is elaborated. To validate the feasibility, simulation and experiment results are included in the text as well.

Robust input-output decoupling control for induction motors

ADAPTIVE STATOR FLUX AND TORQUE DECOUPLING CONTROL OF INDUCTION MOTORS

Stator Flux and Torque Decoupling Control for Induction Motors with Resistances Adaptation

Sensorless Control Strategy for Multiphase Induction Motor with Stator and Rotor Resistance Identification Based on Injecting Third Harmonic Current

A New Reactive Power-Based Sensorless Control Strategy For Five-Phase Induction Motor With Non-Sinusoidal Power Supply

An Adaptive Observer Design for Sensorless Control of Induction Motors

Input-output Decoupling Control of Induction Motors Based on Rotor-Field-oriented Control

Control Of Induction Motor Drive Based On Adrc And Inertia Estimation

Vector Control System of Induction Motor Based on Feed-Forward Decoupling Scheme

Adaptive Direct Torque Control for Induction Motors with Unknown Resistances

Sensorless Control for Five-phase Induction Motors With Improved Third-harmonic Current Injection

A Novel Complex Vector Decoupling Control Method of IPMSM with Fuzzy Strategy

A new full-speed range direct torque control strategy for induction machine

Fault-Tolerant Control of Five-Phase Induction Motor under Single-Phase Open

Online Decoupled Stator and Rotor Resistances Adaptation for Speed Sensorless Induction Motor Drives by a Time-Division Approach

Direct Resonant Control Strategy for Torque Ripple Mitigation of Dfig Connected to Dc Link Through Diode Rectifier on Stator

The Decoupling Control of Induction Motor with the Inverse System Method

Induction Machine Flux Weakening Control Strategy Based on the Load Torque

Predictive control of torque and flux of induction motor drives

A novel control strategy of induction motors for the optimization of both efficiency and torque response

A Robust Nonlinear Controller for Induction Motor