Abstract:The major topology for wireless power transfer is resonant converters, which use fundamental harmonic approximation as a general analysis method. The accuracy of fundamental harmonic approximation (FHA) is unsatisfactory in some wireless power transfer applications, as the current has distortions due to the non-linear diode-bridge rectifier. Some frequency-domain models also consider harmonics beside fundamental component and indeed have a higher resolution. However, due to the difficulty of modeling the non-linear rectifier, most models are oversimplified by assuming a voltage source on the output to eliminate the rectifier. Moreover, the value of the voltage source is often treated as a fixed given number, which is not true for a resistive load. To cover a general case, this paper proposes a frequency-domain analytical model for resonant converters in continuous current mode (CCM) with the capability of considering any load and source situations in kHz frequency range. In terms of computation complexity, the proposed model only involves matrix operation (first-order). A simple algorithm has been chosen to demonstrate the fast convergency and high accuracy of the proposed model. The main findings are verified by the comparison between the theoretical calculation, time-domain simulation and experimental results, where the estimation of output power has 10% improvement than the FHA method.

Nonlinear Large-Signal Modeling of PWM DC-DC Switching Power Converters

Modeling and Control for DC-DC Converters Based on Hybrid System

Design and Simulation of a PFM-PWM Hybrid Controller for DCDC Converter with CLLC Topology

A new modeling method for DC-DC converter based on Verilog-A

Analytical Modeling of Resonant Converters in Frequency Domain for Wireless Power Transfer: Continuous Current Mode (CCM) Operation

A Family of PWM Plus Phase-Shift Bidirectional DC-DC Converters

Modeling and Parameter Identification of DC/DC Converters in Both CCM and DCM Mode

Modeling and Analysis of PWM Converters with a New GSSA Method

Large-signal model by means of gyrators for buck converters

Small Signal Modeling And Analysis Of Interleaved Active-Clamp Forward Converter With Parallel Input And Series-Parallel Output

Sigmoid function model of parallel-connected DC–DC converters and analysis of their dynamic characteristics

Multiscale Modeling and Analysis of Boost Converter Based on Device Mechanism Model and Continuous Switching Function

Dynamic Modeling for a Bi-directional DC/DC Converter with Two Regulative Parameters

Modeling, Analysis and Design of 15kw Zero-Voltage Zero-Current Switched Full Bridge PWM Converter

Dynamic Model of PWM Plus Phase-Shift (PPS) Control Bidirectional DC-DC Converters

Generalized Pulse Width Modulation Switch Model for Converters Based on the Multistate Switching Cell in Discontinuous Conduction Mode

Universal Approach To Modeling Current Mode Controlled Converters In Distributed Power Systems For Large-Signal Subsystem Interactions Investigation

Analysis and Design-Optimization of LCC Resonant Converter Operating under Wide Range Input and Output Voltage

A Simplified Small-signal Analysis Method for LLC Series Resonant Converter

Unified Small-Signal Model for DC-DC Converters Based on The Four-State Switching Cell in Discontinuous Conduction Mode

A Two-Piece Sigmoid Model for High-Order Power Electronics Converters and an Analysis of Their Dynamic Behaviors