Abstract:The phenomenon of load currents with long decaying tails can be found on many pulsed-power generators, such as the Z accelerator at Sandia National Laboratories in the U. S. and the Angara-5-1 facility in Russia. In this paper, the reasons that cause the load current tail on the Qiangguang generator are investigated. The experiments were carried out using two insulator stacks with different diameters and insulator ring numbers. The results show that the current tail on the Qiangguang generator is not caused by measurement error but rather by electrical flashover across the surface of the insulator stack and by leakage current through the water between the stack and the outer wall of the water-filled transmission line that feeds the vacuum section on the Qiangguang generator. Also, an equivalent circuit for the Qiangguang generator was constructed and used in PSpice simulations. By adding a time-dependent resistance in parallel with the load, the simulations were able to produce current waveforms that closely match those recorded during experiments. In additional experiments, an optical fiber was used with a photoelectric cell to collect the flashover light emitted from the surface of the vacuum-insulator rings. The data collected show that the fiber signal and the beginning of the load current tail are time correlated. More recently, a new insulator stack made of Rexolite was acquired and used in yet more experiments. The results of these experiments show that, by using the new insulator stack, the onset of the load current tail phenomenon is significantly delayed. The data from all of the experiments show that stack flashover is the main cause of the load current tail on the Qiangguang generator.

Zero Dimensional Simulation Method for Wire Array Z-pinch on Qiangguang I Generator

Simulation of Planar Wire Array Z-pinch Based on Single Wire Behavior

Numerical Simulation of Tungsten Wire-Array Pinch Plasma

Investigating the Influence of the Wire-Arrays’ Electrical Parameters on the Load Current of the Z-Pinch Drivers

Primarily Experimental Results for a W Wire Array Z Pinch

Conversion of electromagnetic energy in Z-pinch process of single planar wire arrays at 1.5 MA

Investigation of the Resistance and Inductance of Planar Wire Array Z-Pinch at the Qiangguang Accelerator

Optimal design on parameters of Z-pinch wire-array load

Study on W Wire Array Z Pinch Plasma Radiation at Qiangguang- Ⅰ Facility

Wire array experiments in a low impedance and low current generator

Optical Imaging System for Wire Array Z-pinch on "Qiangguang-I"

Experimental Study of Surface Insulated-Standard Hybrid Tungsten Planar Wire Array Z-Pinches at "Qiangguang-I" Facility

Initial Behaviors of the Preconditioned Wire Array Z-pinches

Researches on Preconditioned Wire Array Z Pinches in Xi’an Jiaotong University

Characteristics of Implosion and Radiation for Aluminum Planar Wire Array Z-Pinch at 1.5 MA

Suppressing the Asymmetrical Structures of the Wire Array Z-pinch

Experimental Investigations of X-Pinch Backlighters on Qiangguang-1 Generator

Preliminary Experimental Results Of Tungsten Wire-Array Z-Pinches On Primary Test Stand

Investigation of the Load Current Tail Phenomenon on the Qiangguang Generator

Research of Implosion Dynamics for Wire Array Z Pinch

X-ray Backlighting of Wire Expansion and Plasma Merging of Z-Pinch Load with 10-40Ka/wire