Abstract:Agile development is considered as an emerging trend in hardware design, and NoC-based multi-IP integrated system has become the mainstream solution. The most critical challenge of this solution is to design a common efficient NoC with ultra-high throughput and low-cost routers to meet the communication characteristics of varied applications. Usually, NoC can not achieve both the gains from high throughput and low cost because high-throughput router architectures need complex virtual channel control logic to ensure that the power consumption and area of buffers will not be too large. Meanwhile, the low-cost router architecture is difficult to achieve higher throughput by increasing the number of buffers due to its simple control circuits. Moreover, most routers in NoC are optimized only for specific applications. To address the problem, this paper presents a “viaduct theory” for throughput optimization and realizes a common NoC router architecture for different scenario requirements (CRAFT router). Firstly, we improve the top boundary of the router throughput with the fully-connected crossbar switch, which is an expensive solution for high throughput. Secondly, we use a method similar to the ring-decouple theory in low-cost routers to reduce the number of router buffers while maintaining high throughput. The experimental results show that the throughput for the low-cost program is 15.4% higher than the conventional router with the same overhead. For the high-performance program, our router saves 50% hardware overhead compared with fully-connected routers with the same throughput; The maximum throughput that can be achieved is 26.3% higher than conventional routers, and 14.2% higher than the other state-of-the-art designs.

CEE-Gr: A global router with performance optimization under multi-constraints

Performance Optimization Global Routing with RLC Crosstalk Constraints

Scheduling Model and Performance Analysis in Transport Mapping Layer of Control Element in Forwarding and Control Element Separation System.

A Fast and High-Performance Global Router with Enhanced Congestion Control

An Efficient Global Router for Large-scale Congestion-driven Routing

A Performance-Driven Global Router Considering Crosstalk Optimization

A novel and efficient timing-driven global router for standard cell layout design based on critical network concept

VFGR: A very fast parallel global router with accurate congestion modeling

Algorithm for Post Global Routing RLC Crosstalk Avoidance

A Coupling and Crosstalk Considered Timing-Driven Global Routing Algorithm for High Performance Circuit Design

Performance evaluation of a multi-granularity and multi-connectivity circuit switched network

Bcdrouter: Global Routing Considering Cmp And Via Reduction

A Fast and Efficient Global Router for Congestion Optimization

A global-aware bandwidth-constraint routing scheme for Network-on-Chip

A New Multi-Layer Global Routing Flow For Congestion Elimination

A Robust FPGA Router with Optimization of High-Fanout Nets and Intra-CLB Connections

A Novel Fine-Grain Track Routing Approach For Routability And Crosstalk Optimization

General Routing Architecture Modelling and Exploration for Modern FPGAs

CNB: A Critical-Network-based Timing Optimization Method for Standard Cell Global Routing

The key technologies of performance optimization for nanometer routing

CRAFT: Common Router Architecture for Throughput Optimization.