Abstract:A detailed chemical kinetics model was used in a computational fluid dynamics (CFD) code to study the combustion process of a homogeneous charge compression ignition (HCCI) engine fuelled with isooctane. The detailed chemical kinetics code CHEMKIN was implemented into the multi-dimensional CFD code KIVA-3V so that the chemical reactions and in-cylinder flow were coupled. The results indicate that the grid density and time step have little influence on the accuracy of the computational analysis of the HCCI combustion process; however, the initial temperature of the charge influences the burn point greatly. A comparative study on submodels indicates that the results calculated by the renormalization group k-ε turbulence model, the Han-Reitz heat transfer model, and the crevice flow model agree better with measurements than their counterparts, the standard k-ε turbulence model, the traditional heat transfer model, and the non-crevice flow model respectively. The modified multi-dimensional model predicts with good accuracy the pressure, heat release rate, and emissions under different equivalence ratios. The benefits and limits of four approaches extending the operation range of HCCI engines to higher load, i.e. retarded burn point by decreasing the intake temperature, enhanced thermal stratification by lowering the cylinder wall temperature and increasing the swirl ratio, and increasing the exhaust gas recirculation (EGR) ratio, were analysed by this model. The results indicate that proper combustion phasing retardation can reduce the ringing intensity significantly and maintain the performance and emissions level. Among these four methods, increasing the swirl ratio could reduce the ringing intensity most significantly, while EGR shows an excellent performance in all aspects.

The Simulation of HCCI Engine Combustion Using Detailed Chemical Kinetics Model

Simulation of Influences of Catalytic Combustion on the Emissions of HCCI Engine

Comparison of Kinetic Mechanisms for Numerical Simulation of Methanol Combustion in DICI Heavy-Duty Engine

Numerical and Experimental Study on HCCI Combustion Process of N-Heptane

Numerical Simulation of Homogeneous Charge Compression Ignition Combustion Using A Multi-Dimensional Model

Numerical Simulation of HCCI Engine with Multi-Stage Gasoline Direct Injection Using 3D-CFD with Detailed Chemistry

Study of HCCI Combustion Characteristics with High RON Fuel

Numerical Simulation of Combustion in HCCI Engine Using Multi-Dimensional Model(Ⅰ)——Construction and comparison of models

A Chemical Kinetics Model of Iso-Octane Oxidation for Hcci Engines

The Simulation of HCCI Engine with a Multi-Zone Model

Numerical Simulation of Gasoline Stratified Charge Compression Ignition Using 3D-CFD Coupled with Detailed Chemistry

Modeling of HCCI combustion: From 0D to 3D

A computational study of direct injection gasoline HCCI engine with secondary injection

Multi-dimensional Modeling of the Application of Catalytic Combustion to Homogeneous Charge Compression Ignition Engine

Study on the Methanol/n-Heptane Duel Fuel Homogeneous Charge Compression Lgnition Combustion

Multi-dimensional simulation of HCCI engine using parallel computation and chemical kinetics

Numerical Investigation on the Application of Catalytic Combustion to HCCI Engines

Modeling and Experimental Study on Quasi-HCCI Combustion

Artificial Neural Network Based Chemical Mechanisms for Computationally Efficient Modeling of Hydrogen/carbon Monoxide/kerosene Combustion

Numerical simulation of the coupling of pressure wave and chemical kinetics in HCCI combustion

Comparison of Single-zone and Multi-zone Combustion Model for HCCI Engine