Abstract:During the commissioning of Nuclear power plant unit, it is necessary to perform the transient condition test that the single pump operation of Main Feedwater (APA) pump triggers the rapid load rejection of steam turbine. Due to the sudden loss of a main water supply pump during the test, the level of the steam generator will change dramatically. If there is a signal of "SG level low plus steam / water flow mismatch" or a signal of "SG level low low", the reactor trip protection will be triggered. PI controller is used as the core controller of the main feed water pump control process. The optimal parameters of PI controller directly affect the level control performance of steam generator. At present, the units that have completed the test only verify that the control system meets the requirements of transient conditions, but it does not solve the phenomenon that the oscillation frequency of the feed water regulating system is too high under stable conditions. In this paper, the safety range of the control parameters under transient condition is determined by simulation model test, and then the steady-state performance of the parameters is improved by field test, so the optimization of the control parameters is completed, and the regulation performance of the feed water control system under single pump operation and steady-state condition of the main feed water pump is improved, and practical results are achieved. The results show that the optimization of the controller parameters in this paper can meet the requirements of transient conditions, and can effectively increase the stability of the control system. This research method has been successfully applied in generation II unit, and it is also useful for the generation-III unit.

An Analytical Method to Design the PID Controller for the Power Control System of Experimental Nuclear Reactor

Performance monitoring and assessment for PID controller

On PID Controllers Based on Simulated Annealing Algorithm

Intelligent Optimization Design of PID Controller for Integrating Processes

Study on Optimization of PID for Feed-water Control System of RB Test in PWR Nuclear Power Station

Performance assessment of PID controller with time-variant disturbance dynamics

Novel PID Controller Parameters Tuning Method.

Optimization Design Based on PSO Algorithm for PID Controller

An Expert PID Control Method for Level Control of CFB Boiler

PID Controller Design for Single-Phase Inverter Based on Root Locus Method

A Novel Robust PID Design Method for Uncertain System

The Fuzzy Model PID Optimization Control Designed for a Heat Exchange System in a Packed Tower

Use Orthogonal Experimental Method to Regulate PID Parameters

Study on applying Fuzzy-PID control in power control of nuclear reactor

PID control system analysis and design

Fuzzy Model PID Optimization Control Applied in Nonlinear System

Nuclear Reactor Power Controller Design Method

Modified PID controller based on H/sub /spl infin// theory

Study on Characteristic of Reactor Power Regulating System

Study of PID Control Algorithm Based on the Critical Ratio Method

Nonlinear Pid Control for the Boiler- Turbine Systems of Power Unit