Abstract:Aiming at reducing the estimation error of the sensor frequency response function (FRF) estimated by the commonly used window-based spectral estimation method, the error models of interpolation and transient errors are derived in the form of non-parameter models. Accordingly, window effects on the errors are analyzed and reveal that the commonly used hanning window leads to smaller interpolation error which can also be significantly eliminated by the cubic spline interpolation method when estimating the FRF from the step response data, and window with smaller front-end value can restrain more transient error. Thus, a new dual-cosine window with its non-zero discrete Fourier transform bins at -3, -1, 0, 1, and 3 is constructed for FRF estimation. Compared with the hanning window, the new dual-cosine window has the equivalent interpolation error suppression capability and better transient error suppression capability when estimating the FRF from the step response; specifically, it reduces the asymptotic property of the transient error from O(N-2) of the hanning window method to O(N-4) while only increases the uncertainty slightly (about 0.4 dB). Then, one direction of a wind tunnel strain gauge balance which is a high order, small damping, and non-minimum phase system is employed as the example for verifying the new dual-cosine window-based spectral estimation method. The model simulation result shows that the new dual-cosine window method is better than the hanning window method for FRF estimation, and compared with the Gans method and LPM method, it has the advantages of simple computation, less time consumption, and short data requirement; the actual data calculation result of the balance FRF is consistent to the simulation result. Thus, the new dual-cosine window is effective and practical for FRF estimation. Published by AIP Publishing.

Convolution Window and Application in AC Electrical Parameters Estimation

Estimation of electrical harmonic parameters by using the Interpolated FFT algorithm based on Blackman window.

A Two-step Method for Estimating DFIG Parameters in a Wind Turbine and the Measurement Selection

Frequency-domain Sensitivities with Application to Power System Modeling

A DC Estimation Method to Improve the Accuracy of DC Power Flow

A Quadratic Constraint Quadratic Estimation Model for Three-phase Distribution Network State Estimation

Interharmonics Analysis Based on Interpolating Windowed FFT Algorithm

Power System Harmonic Parameters Estimation Based on Recursive DFT Algorithm with DRSC Window

Study on the Approachs of Electrical Harmonic Analysis for Asynchronous Sampling

Voltage Flicker Parameter Estimation Based On Improved Analytic Energy Operator And Novel K-B Mutual Convolution Window

Hanning Self-Convolution Window and Its Application to Harmonic Analysis

A new algorithm for electric energy measurement based on four-order Hanning self-multiplication window triple-spectrum-line interpolation FFT

Network Parameter Identification and Estimation Based on Hybrid Measurement of WAMS/SCADA

New Explanation of Frequency Domain Methods for Harmonic Analysis and Its Generalization

Error Analysis And New Dual-Cosine Window For Estimating The Sensor Frequency Response Function From The Step Response Data

An Electrical Parameter Measurement System Based on DSP and LabVIEW

Four Harmonic Analysis and Energy Metering Algorithms Based on a New Cosine Window Function

An Adaptive Window Function Method for Power Measurement

REAL TIME ESTIMATION OF POWER SYSTEM FREQUENCY

Circuit-theoretic Joint Parameter-State Estimation -- Balancing Optimality and AC Feasibility

A new algorithm for electric energy measurement based on Hanning self multiplication-convolution window triple-spectrum-line interpolation FFT