Abstract:Fault identification and diagnosis of steam turbine generator unit is very important for safely and economically operation of a power plant. Currently, on-line monitoring is already widely utilized for. alarming and recording in steam turbine. However, large amount of on-line monitoring data is not fully utilized to realize on-line fault diagnosis and identification, especially multi-concurrent fault. In the present study, model-based method was used for on-line vibrational fault identification and diagnosis based on rotordynamics. A 660MW supercritical steam turbine rotor system was modeled using FEM. Single faults, such as mass unbalance, local shaft bow and transverse crack, and multi-concurrent faults were simulated. Fault-induced changes of equivalent loads were analyzed to figure out fault type, location and severity. For model-based method, fault diagnosis accuracy is influenced by the model accuracy and signal noise. Model sensitivity was studied in this research by comparing the influence of different model error and SNR (Signal to Noise Ratio). It was used to evaluate the degree of confidence of the diagnosis result. The smaller was the model sensitivity, the higher was the degree of confidence. Based on this research, model-based method was utilized to analyze real vibration signals extracted from the historical data of this unit. Fault identification result was an effective basis for conditioned based maintenance.

ROUGH SET MODEL FOR VIBRATION FAULT DIAGNOSIS OF STEAM TURBINE-GENERATOR SET

The Application of Mechanical Failure Diagnosis Expert System for the Improvement of Vibration Fault Monitor and Diagnosis Based on Rough Set Theory

Intelligent Fault Diagnosis of CNC Machine Tools Based on Rough Set Theory

Fault Diagnosis Of Mechanical Equipment Based On Data Visualization

Fault Diagnosis Method of Rotating Machinery Based on Rough Set Theory

Cost-sensitive fault diagnosis based on minimum expectedcost criterion for steam turbine

DIAGNOSTIC MODEL OF INSULATION FAULTS IN POWER EQUIPMENT BASED ON ROUGH SET THEORY

A New Model of Mine Hoist Fault Diagnosis Based on the Rough Set Theory.

A new model of fault diagnosis based on the rough set theory

FAULT DIAGNOSIS FOR POWER EQUIPMENT BASED ON ROUGH SET METHOD

Fault Diagnosis of Steam Turbine Vibration Based on Fault Tree Analysis

Cost-sensitive Fault Diagnosis Based on Weighted Rough Sets

Approach for fault detection and diagnosis based on rough set

A Method That Rough Set Theory is Used on Fault Diagnosis with Establishing the Decision Table of Divided Piece

Turboset Vibration Fault Diagnosis Knowledge-base System Based on the Dual Factors Method

Rule Acquisition Method of Hoist Fault Based on Rough Set

Fault Diagnosis on Rotating Machinery Based on Fuzzy C-means Clustering and Rough Set Theory

A New Fault Diagnosis Method for a Rotor of a Steam Turbine Generator Set Based on Instantaneous Energy Distribution Characteristics

Identification Of Multi-Concurrent Fault In A Steam Turbine Rotor System Using Model-Based Method

Fault Diagnosis of Rotating Machinery Based on SVD, FCM and RST

The Fault Diagnosis of Power Transformer Based on Rough Set Theory