Abstract:Resonance and performance analysis of a harmonically forced Quasi-Zero-Stiffness (QZS) vibration isolator considering the effect of mistuned mass is presented in this paper. The QZS vibration isolator is comprised of vertical spring used as load bearing element and inclined springs used as negative stiffness correctors. The dynamic motion of the QZS vibration isolator considering the effect of mistuned mass can be approximately described by the Helmholtz-Duffing equation. Firstly, the primary resonance is obtained by using Harmonic Balance Method (HBM). Different shapes of Frequency Response Curves (FRCs) are found for different combinations of mistuned mass and force amplitude. The influence of excitation amplitude and damping ratio on the primary resonance are considered. The peak amplitudes of primary resonance and stability analysis are also investigated. Then the 1/2 subharmonic resonance, the phenomenon of period-doubling bifurcations and their development into chaotic motion are analyzed by approximate analytic and numerical methods. The bifurcation diagram, time histories, Fourier spectra, phase plane plots and Poincare maps are used to show this development. Finally, force transmissibility is proposed to evaluate the performance of the QZS vibration isolator and compared with an equivalent linear vibration isolator. The results show that the QZS vibration isolator can outperform the equivalent linear one to offer a wider isolation frequency band and lower maximum transmissibility when the excitation amplitude is not too large.

Impediment to Structure-Borne Sound Propagation from Vibration Isolation Mass

Impediment to Structure-Borne Sound Propagation from Several Paralleling Arranged Vibration Isolation Mass

Vibration characteristics and isolation in vibration-sensitive areas under moving vehicle load

Force and displacement transmissibility of a quasi-zero stiffness vibration isolator with geometric nonlinear damping

Resonance and Performance Analysis of a Harmonically Forced Quasi-Zero-Stiffness Vibration Isolator Considering the Effect of Mistuned Mass

Research on Vibration Transmissibility of Vibration Isolation System with Complex Vibration Environment

BASIC THEORY AND TECHNOLOGY IN THE ACTIVE VIBRATION ISOLATION OF PRECISION DEVICES

Analysis of Vibration Isolation of a Row of Rigid Piles to Plane SV Waves in Saturated Soil

Analysis of vibration transmission at the corner interface of two plates for reduction of structure-borne sound

On the Vibration Isolation of Flexible Structures

Analysis of the Effect of Blocking Mass at Corner Interface of Two Plates at Arbitrary Angles on Transmission of Plane Bending Waves

Analytical Study of Vibration Isolation Between a Pair of Flexible Structures

Theoretical analysis on active vibration isolation and underwater sound radiation

Analysis for the Principle of Whole-Spacecraft Vibration Isolation

Multifunctional Metamaterials for Simultaneous Sound Absorption and Flexural Vibration Isolation

Experimental Study on Active Vibration Isolation and Underwater Sound Radiation Control

Analysis of Resonance Suppression Performance of a Time-Varying Isolation Platform

Vibration Isolation Using Pile Rows In A Layered Poroelastic Half-Space Against The Vibration Due To Harmonic Loads

Vibration isolation for moving loads with different velocities by using piles-in-row embedded in an elastic medium

Vibration Isolation Design for Submarine Base Structure Based on Principle of Impedance Mismatch

Structure-borne Sound Attenuation at Corner Interface with Dynamic Vibration Absorber Attached