Abstract:Surface flashover phenomena in vacuum across dielectrics usually happen in many pulsed power devices, high power microwave (HPM) equipment and particle accelerators. Secondary electron emission avalanche (SEEA) model is generally accepted to analyze this phenomena. During the evolution of flashover development, the process of electrons desorption stimulated (ESD) gases plays a dominant role and then leads to final discharge formation. Accurate measurement of ESD gas components and its quantity is very helpful to investigate flashover mechanism and make theoretical simulation. In this paper, an ESD measurement apparatus is set up with a modified quadrupole mass spectrometer (QMS) surround with double cooling shrouds. The incident electron energy varies from 2keV to 7keV. First, residual gas in the experiment chamber is analyzed. Next, pulsed electron beam impacts the sample surface and release ESD gases, and then mass spectrum analysis of ionized gases is carried out by QMS. The differences before and during electron irradiation are regarded as the amount of desorbed gases. Some typical dielectrics are measured including PTFE, PE and Al 2 O 3 . It is found that main desorbed gas components are similar, i.e. H 2 , H 2 O, CO, CO 2 , etc. Additionally, electrons irradiation can break chemical bonds to produce new components. H 2 accounts for the majority of total desorption gases. Organic material (PE) has higher desorption gas than that of Al 2 O 3 .

Dynamical Model in Low-Frequency-Pulsed Electron-Stimulated Desorption

Numerical Simulations on a Nanosecond-Pulse Exciplex Pumped Cesium Vapor Laser

Modeling of Three-Dimensional Exciplex Pumped Fluid Cs Vapor Laser with Transverse and Longitudinal Gas Flow

Modeling of a diode transverse-pumped cesium vapor laser

A Dynamical Model of Microwave Window Breakdown at Vacuum/dielectric Interface

Heat and mass transfer model for desiccant solution regeneration process in liquid desiccant dehumidification system

Dynamic model for CuBr UV laser

Monte Carlo simulation of gas desorption process induced by low-energy ions

Numeric modeling of synchronous laser pulsing and voltage pulsing field evaporation

Modeling of Flowing Gas Discharge – Part I

MOLECULAR DYNAMICS SIMULATION OF PULSED LASER ABLATION

Coupling Model of Motion and Mass Transfer in Multicomponent Desorption of Fine Bubbles

A Dynamic Droplet Breakup Model for Eulerian-Lagrangian Simulation of Liquid-fueled Detonation

A time-delay model for molecular gas flow into vacuum

Modeling of Nanosecond Pulsed Surface Dielectric Barrier Discharge of N2-O2 Mixture at Atmosphere Presuure

Dynamical theory of fluorescence depletion in ultrafast reaction

Computational Model for Predicting the Dynamic Dissolution and Evolution Behaviors of Gases in Liquids

Electrons stimulated gas desorption of some dielectrics in vacuum

Simulation Model of Streamer Discharge in Dielectric Liquid under Positive Nanosecond Pulse

Mechanisms of electrospray jet formation and atomized droplet motion in pulsed-jet mode

Hot electron mediated desorption rates calculated from excited state potential energy surfaces