Abstract:Near-infrared spectroscopy is often used for the non-invasive detection of composition in the human body, such as that of blood glucose and haemoglobin, due to its high penetration depth into tissues. Although it is feasible to position the optical probe precisely, contact situation between probe and human tissues is a difficult problem to determine because of physiological tremor and mechanical performance of bio-soft tissue. Here, we proposed a novel estimation method for the situation between the optical probe and tissue surfaces based on the dynamic auto-correlation matrix of two-dimensional correlation spectroscopy (2DCOS) and radar chart. The diffuse reflectance spectra from the left palm of 4 healthy volunteers were collected while the optical probe gradually approached and pressed bio-tissues with a custom-design controlling device. 2DCOS in the wavelength with lower absorption (1000-1400 nm) was calculated under the perturbation of relative-distance and contact pressure between the optical probe and tissue surface. The synchronous 2DCOS showed that the surface reflection and diffuse reflectance were greatly affected by the contact conditions in 1100 nm, 1220 nm, and 1300 nm. Then the dynamic auto-correlation matrix of 2DCOS was established for the adjacent spectra, and the significant difference wavelengths were used to build radar charts to determine the critical contact situation visually. Results showed that the maximum variations of dynamic auto-correlation matrix appeared at near 1300 nm, and the relative distance between the probe and tissue corresponding to the critical contact state can be easily observed with radar charts with 0.25 mm uncertainty, which was consistent with the self-feeling of each volunteer. So this method can be applied to exactly determine the optimal measurement status for the non-invasive body composition detection in vivo. It is important for the design of human-machine interface and the accuracy improvement of body composition measurements.

A Fast Method To Measure The 3d Surface Of Human Heart

Profile analysis of ventricle specimen based on a new phase measuring method

A New Dynamic Surface Reconstruction Method for Cardiac 3D Mapping Procedure

Research on the Best Measurement Situation Between Optical Probe and Tissue Surfaces in Non-Invasive Detection.

3D Measurement of Human Chest and Abdomen Surface Based on 3D Fourier Transform and Time Phase Unwrapping

Biomechanics Analysis on Human Heart by Establishment of Three-Dimension Model and Finite Element Method

3-D Measurement of Body Tissues Based on Ultrasound Images with 3-D Spatial Information

Extraction of the Optimal Cross Section in Real-Time Heart 3D Ultrasound Images for Heart Hemodynamics

Medical 3D body of data measurement method geometry

A Deep Learning-Based Method for Rapid 3D Whole-Heart Modeling in Congenital Heart Disease

A Novel Reconstruction Method of 3D Heart Geometry Atlas Based on Visible Human

Non-contact Real-time Heart Rate Measurements Based on High Speed Circuit Technology Research

A Novel Approach for 3d Surface Reconstruction of Lv Endocardium Based on Spcnn and Mc

3D measurements in craniofacial surgery simulation system

Primary Study of Three-Dimensional and Automatic Facial Measuring System Based on Laser Scanning

Automatic Measurement of Scanned Human Body in Fixed Posture

Fast and Automated Creation of Patient-Specific 3 D Heart Model from Tagged MRI

[3D Virtual Endoscopy of Heart].

Progressive Surface Reconstruction of Cardiac Anatomy from Sparse and Scattered Points for Heart Mapping Procedure

Three Dimensional Reconstruction of Heart Based on Chinese Digitized Visible Human

Heart Modeling of Finite Element Based on Rapid Generation of Tetrahedral Mesh