Abstract:The paper addresses the method for stator and rotor resistance identification in speed sensorless induction motor drives. The instability problem caused by pure integration of the voltage model (VM) of rotor flux is handled by introducing correction terms in the VM. It is, however, shown that the third-order persistent excitation (PE) condition for simultaneous identification of stator, rotor resistances and rotor speed can barely be satisfied even with extra excitations in rotor flux modulus command. And an adaptive observer that is not persistently excited may become instable when exposed to bounded disturbances. Hence, to design a robust flux observer, concept of time-division multiplexing is incorporated into the observer design. That is, stator resistance is identified as the flux modulus is flat, while rotor resistance is adapted as a ramp flux modulus command is applied. This relaxes PE condition to order two, and as a drawback, the ramp flux modulus command incurs speed ripples. The decoupled identifiability of stator resistance is designed and explained, a rigorous input-to-state stability analysis of both the mismatch [between VM and current model (CM)] and the error (between actual rotor flux and CM) is set forth, and a convergence analysis of parameters is elaborated. To validate the feasibility, simulation and experiment results are included in the text as well.

Speed Identification for Vector Control of Induction Motors with Voltage Decoupling Control Principle

Speed Identification for Speed Sensorless Vector Control of Induction Motors Based on Voltage Decoupling Control Principle

Speed-sensorless Direct Torque Control System of Induction Motor

Research on Voltage Decoupling Control of Vector Control for Permanent Magnet Synchronous Motor

The Decoupling Control of Induction Motor with the Inverse System Method

Decoupling and Vector Control of Induction Motor

Vector Control System of Induction Motor Based on Feed-Forward Decoupling Scheme

Online Decoupled Stator and Rotor Resistances Adaptation for Speed Sensorless Induction Motor Drives by a Time-Division Approach

Novel Speed Sensorless Vector Control with Adaptive Rotor Flux Identification of Induction Motors

Speed Sensorless Vector Control of an Induction Machine in Low Speed Range

A NOVEL SLIDING MODEL DECOUPLING AND SELF TUNNING CONTROL FOR INDUCTION MOTOR SPEED CONTROL SYSTEM

Speed-Sensorless Control of Induction Motor Drives with A Delay-Based Frequency Estimation Method

Open-Loop Validation of a decoupled model of an Induction Motor Supplied by a PWM Inverter

Speed-Sensorless Control of Induction Motor Drives with a STA-FLL Speed Estimation Scheme

Vector Control of a Speed Sensor-Less Induction Motor at Very Low Speed

Study on rotor flux-oriented speedless sensor vector control method of induction motor

Virtual vectors based predictive control of torque and flux of induction motor and speed sensorless drives

Vector Control System of Induction Motor Based on Decoupling Scheme

A Speed Sensorless Vector Control System of Induction Motor Based on DSP

Speed Sensor-Less Control of an Induction Motor with Rotor Flux Tracking at Very Low Speed

Speed Regulation of Induction Motor Using Sliding Mode Control Scheme