Abstract:Some h-p finite element computations have been carried out to obtain solutions for fully developed laminar flows in curved pipes with curvature ratios from 0.001 to 0.5. An Oldroyd-3-constant model is used to represent the viscoelastic fluid, which includes the upper-convected Maxwell (UCM) model and the Oldroyd-B model as special cases. With this model we can examine separately the effects of the fluid inertia, and the first and second normal-stress differences. From analysis of the global torque and force balances, three criteria are proposed for this problem to estimate the errors in the computations. Moreover, the finite element solutions are accurately confirmed by the perturbation solutions of Robertson & Muller (1996) in the cases of small Reynolds/Deborah numbers.Our numerical solutions and an order-of-magnitude analysis of the governing equations elucidate the mechanism of the secondary flow in the absence of second normal-stress difference. For Newtonian flow, the pressure gradient near the wall region is the driving force for the secondary flow; for creeping viscoelastic flow, the combination of large axial normal stress with streamline curvature, the so-called hoop stress near the wall, promotes a secondary flow in the same direction as the inertial secondary flow, despite the adverse pressure gradient there; in the case of inertial viscoelastic flow, both the larger axial normal stress and the smaller inertia near the wall promote the secondary flow.For both Newtonian and viscoelastic fluids the secondary volumetric fluxes per unit of work consumption and per unit of axial volumetric flux first increase then decrease as the Reynolds/Deborah number increases; this behaviour should be of interest in engineering applications.Typical negative values of second normal-stress difference can drastically suppress the secondary flow and in the case of small curvature ratios, make the flow approximate the corresponding Poiseuille flow in a straight pipe. The viscoelasticity of Oldroyd-B fluid causes drag enhancement compared to Newtonian flow. Adding a typical negative second normal-stress difference produces large drag reductions for a small curvature ratio δ = 0.01; however, for a large curvature ratio δ = 0.2, although the secondary flows are also drastically attenuated by the second normal-stress difference, the flow resistance remains considerably higher than in Newtonian flow.It was observed that for the UCM and Oldroyd-B models, the limiting Deborah numbers met in our steady solution calculations obey the same scaling criterion as proposed by McKinley et al. (1996) for elastic instabilities; we present an intriguing problem on the relation between the Newton iteration for steady solutions and the linear stability analyses.

Solution behavior of the falling sphere problem in viscoelastic flows

Limiting Behavior of the Solutions of A Falling Sphere in A Tube Filled with Viscoelastic Fluids

A Volume of Fluid Method Algorithm for Simulation of Surface Tension Dominant Two-Phase Flows

Stress Boundary Layers in the Viscoelastic Flow Past a Cylinder in a Channel:Limiting Solutions

Viscoelastic mobility problem of a system of particles

A Fictitious Domain Method for Dynamic Simulation of Particle Sedimentation in Bingham Fluids

Dynamic Simulation of Sphere Motion in a Vertical Tube

Falling Film Flow of a Viscoelastic Fluid along a Wall

Finite difference method in prolate spheroidal coordinates for freely suspended spheroidal particles in linear flows of viscous and viscoelastic fluids

Experimental study on the equilibrium position of a falling sphere in a circular tube flow

Galerkin/least-square Finite-Element Methods for Steady Viscoelastic Flows

Viscoelastic flows of a lid-driven cavity using spectral element methods

Falling balls in a viscous fluid with contact: Comparing numerical simulations with experimental data

Data-driven Closure Model for the Drag Coefficient of the Creeping Flow Past a Translating Sphere in a Shear-Thinning Viscoelastic Fluid

Fully Developed Viscous and Viscoelastic Flows in Curved Pipes

Falling Film on Flexible Wall in the Limit of Weak Viscoelasticity

Numerical Solution of the Navier‐Stokes Equations by the Finite Element Method

The First Solution for the Helical Flows of Generalized Maxwell Fluid with Longitudinal Time Dependent Shear Stresses on the Boundary

Series Solution of Unsteady Boundary Layer Flows of Non-Newtonian Fluids Near A Forward Stagnation Point

An integral equation method for the simulation of doubly-periodic suspensions of rigid bodies in a shearing viscous flow

A numerical stabilization framework for viscoelastic fluid flow using the finite volume method on general unstructured meshes