Abstract:Pipelines are widely used in energy power system including thermal power plants and nuclear power plants. In the power system, especially nuclear power plants, as thermal stratification characteristic of nonuniform temperature distribution in the pipe and thermal fatigue such as the low cycle thermal fatigue due to existence of the cycle thermal stress are inevitable, the pipe line system can be destroyed easily and thus affect the normal operation of the power plants. In order to study the pipeline thermal fatigue, the pipeline thermal stress needs to be calculated and therefore the temperature distributions especially the inner wall temperature was needed. The outer wall temperature and working fluid temperature can be obtained with installing measuring tools. The key and difficult point is the estimation of the inner temperature distribution of the pipe. At the same time, in the practical engineering, the pipeline structure with special safety requirements or higher requirements for structural completeness are not allowed to be destroyed by the measuring equipment. Based on the consideration above, this paper presents a method of solving the inverse heat conduction problem, which means the inner temperature distributions can be derived by the outer wall temperature distributions. For the pipe inverse heat conduction problem, this paper applies numerical analysis as the main way. Firstly, the method for transient inverse heat conduction problems applying separation of variables and Duhamel's theorem is established. As the effects of the random error on the measured outer wall temperature are inevitable, the measured data need to be smoothed before used as an input. The Gram orthogonal polynomial method based on the digital filtering theory is applied in this paper to accomplish the smoothing process. The inverse process is accomplished by using MATLAB programming. Then this method is verified in the experiment with high temperature and high pressure. In order to directly validate the accuracy of the inverse analysis, for the test section, not only the transient outer wall temperature and fluid temperature were measured, but also the time dependent middle layer temperature were measured. Then the middle layer temperature obtained from inverse calculation was compared with the measured data from the experiment. The calculated results show that the accuracy of this method is high. The temperature distributions along the radical direction can be obtained quickly and accurate instantaneous heat load for the structural stress analysis and thermal fatiglie analysis can be provided using this method. (CSPE)

Thermal Analysis of a Straight Buried Pipe

Numerical Analysis of Buried Pipe Characteristics

Thermal Performance of Stratified Fluid-Filled Geomaterials with Compressible Constituents Around a Deep Buried Decaying Heat Source

Analysis on Influencing Factors of Settlement of Buried Pipelines Parallel to Shield Tunnel

Analytical Elastic Solution of Earth Pressure in Deep-Buried Pipe

Temperature field and heat transfer analysis of underground buried pipe

Analysis On Soil Surrounding Temperature Field And Heat Transfer Of Underground Buried Pipe

Comparison between Numerical Simulation and Analytical Calculation of Heat Loss and Temperature Profile of Buried Pipes

NUMERICAL ANALYSIS AND SIMULARITY EXPERIMENT ON TEMPERATURE FIELD OF UNDERGROUND PIPE

A Numerical Solution For The Transient Inverse Heat Conduction Problem

Inversion of the Third Boundary Condition on the Inner Wall of a Two-dimensional Pipe Based on Inverse Heat Conduction Problems

Investigation of the transient heat and mass transfer process in unsaturated porous media around a buried pipe

A thermal-electrical analogy transient model of district heating pipelines for integrated analysis of thermal and power systems

THERMAL POST-BUCKLING OF HIGH-TEMPERATUPE PIPELINE

An extended finite element method for pipe-embedded plane thermal analysis

An Inverse Analysis for the Estimation of Boundary Heat Flux in A Circular Pipe Employing the Proper Orthogonal Decomposition

A Two-Dimensional Enrichment Modelling For Thermal Analysis Of Concrete Cooled By Metal Pipes

The Temperature and Thermal Stress Analysis of Steam Pipe and Correlative Branch Pipe with Finite Element Method

Transient Multidimensional Analysis of Nonconventional Heat Pipes With Uniform and Nonuniform Heat Distributions

Inverse Estimation of the Inner Wall Temperature Fluctuations in a Pipe Elbow

Investigation into the Heat Transfer Models for the Hot Crude Oil Transportation in a Long‐buried Pipeline