Fabrication of the Products with Free-Formed Surfaces Based on Integration of Reverse Engineering and Rapid Prototyping

张征宇,洪军,吴福生,张舜德,丁玉成
DOI: https://doi.org/10.3321/j.issn:0253-987X.2002.07.014
2002-01-01
Abstract:The standards and techniques of the output interface of reverse engineering and the input interface of rapid prototyping are discussed. A new method of rapid development of the products with free-formed surfaces based on the integration of reverse engineering and rapid prototyping is presented to avoid the reconstruction of complicated surfaces in traditional reverse engineering. With this method stereo lithography models are directly generated from point cloud based on cross-section measurement and optical triangulation, and the prototype can be fabricated by rapid prototyping laser system machine. This method can greatly reduce the development cycle of the products with free-formed surfaces, and the cost is dramatically decreased. Finally, taking a digital human body model as the practical engineering case, it is proved that the efficiency of the new product development can be improved by 55%.
What problem does this paper attempt to address?