Abstract:An unstructured mesh model of the west coast of Britain, covering the same domain and using topography and open boundary forcing that are identical to a previous validated uniform grid finite difference model of the region, is used to compare the performance of a finite volume (FV) and a finite element (FE) model of the area in determining tide–surge interaction in the region. Initial calculations show that although qualitatively both models give comparable tidal solutions in the region, comparison with observations shows that the FV model tends to under-estimate tidal amplitudes and hence background tidal friction in the eastern Irish Sea. Storm surge elevations in the eastern Irish Sea due to westerly, northerly and southerly uniform wind stresses computed with the FV model tend to be slightly higher than those computed with the FE model, due to differences in background tidal friction. However, both models showed comparable non-linear tide–surge interaction effects for all wind directions, suggesting that they can reproduce the extensive tide–surge interaction processes that occur in the eastern Irish Sea. Following on from this model comparison study, the physical processes contributing to surge generation and tide–surge interaction in the region are examined. Calculations are performed with uniform wind stresses from a range of directions, and the balance of various terms in the hydrodynamic equations is examined. A detailed comparison of the spatial variability of time series of non-linear bottom friction and non-linear momentum advection terms at six adjacent nodes at two locations in water depths of 20 and 6 m showed some spatial variability from one node to another. This suggests that even in the near coastal region, where water depths are of the order of 6 m and the mesh is fine (of order 0.5 km), there is significant spatial variability in the non-linear terms. In addition, distributions of maximum bed stress due to tides and wind forcing in nearshore regions show appreciable spatial variability. This suggests that intensive measurement campaigns and very high-resolution mesh models are required to validate and reproduce the non-linear processes that occur in these regions and to predict extreme bed stresses that can give rise to sediment movement. High-resolution meshes will also be required in pollution transport problems.

Effects of Nonlinearity and Bottom Friction on Hurricane-Generated Storm Surge in Central Pacific Ocean

Interaction Impacts of Tides, Waves and Winds on Storm Surge in a Channel-Island System: Observational and Numerical Study in Yangshan Harbor

A Numerical Study of Tsunami Wave Impact and Run-Up on Coastal Cliffs Using a CIP-based Model

Effects of Winds, Tides and Storm Surges on Ocean Surface Waves in the Sea of Japan

Numerical Investigation on the Hydrodynamic Characteristics of Coastal Freak Wave Using a CIP-based Model

Modeling of Storm-Induced Coastal Flooding for Emergency Management

Effect of Runoff on Typhoon Storm Surge in Estuaries

Wave-current interaction during Typhoon Nuri (2008) and Hagupit (2008): an application of the coupled ocean-wave modeling system in the northern South China Sea

Effect of wave-dependent mechanisms on storm surge and current simulation during three extreme weather systems

Impact of Multiple Tidal Forcing on the Simulation of the M2 Internal Tides in the Northern South China Sea

Simulating A Typhoon Storm Surge Using A Nested Ecomsed Model

Sediment transport and bed erosion during storm surge using a coupled hydrodynamic and morphodynamic model considering wave and current interaction

Numerical Implementation of Wave Friction Factor into the 1D Tsunami Shallow Water Equation Model

Modelling typhoon-induced waves and surge in the East China Sea

Non-linear interactions between tides and storm surges during extreme weather events over the eastern Canadian shelf

Numerical Simulations Of Tsunami Generation By Using Boussinesq Equations

Discrepancies on Storm Surge Predictions by Parametric Wind Model and Numerical Weather Prediction Model in a Semi-Enclosed Bay: Case Study of Typhoon Haiyan

Modeling of waves overtopping and flooding in the coastal reach by a non-hydrostatic model

Quantifying Compound and Nonlinear Effects of Hurricane‐Induced Flooding Using a Dynamically Coupled Hydrological‐Ocean Model

Modelling tide–surge interaction effects using finite volume and finite element models of the Irish Sea

Effects of Typhoon Paths on Storm Surge and Coastal Inundation in the Pearl River Estuary, China