Abstract:The free-bending process of a metal tube involves a geometric relationship between the eccentricity, the rotation angle of the bending die, the deformation zone length, and the bending radius. Ideally, during the forming process, the contact position between the bending die, and the outer bend of the tube remains tangent. However, due to factors such as the clearance of the bending die and material properties, the rotation angle can be adjusted within a specific range while still ensuring smooth tube formation. The tangential state is disrupted when the rotation angle changes, resulting in overbending or underbending. Thus, in this study, a new theoretical analysis of the free bending process, accounting for clearance, was developed to analyse the material flow and changes in the bending radius during the nontangential contact between the bending die and the tube. In addition, the reasons for achieving smooth tube bending even after adjusting the rotation angle were explained, and the deformation mechanism of the tube under the combined effects of additional tangential force from the bending die and axial propulsive force was analysed. Furthermore, the impact of the rotation angle on the bending radius and the displacement of the strain neutral layer (strain NL) was determined. Afterwards, finite element (FE) modeling and forming experiments were conducted to verify the proposed theoretical analysis under different deformation zone lengths and eccentricities conditions. Besides, the distribution of the inner and outer wall thicknesses of the tube under the nontangential rotation of the bending die was further analysed. The simulation and experimental results fit well with that obtained from theoretical analysis.

Effect of Deformation Condition on Axial Compressive Precision Forming Process of Tube with Curling Die

FEM Analysis of Mechanism of Free Deformation under Dieless Constraint in Axial Compressive Forming Process of Tube

FEM Numerical Simulation of Tube Axial Drawing Process

Development of a finite element simulation system for the tube axial compressive precision forming process

Deformation Patterns in Hydroforming of Thin-Walled Y-Shaped Tube

Effect of Deformation Routes on Torsion Behavior Via ACDR Process

Experimental Study of the Tube Axial Compression Forming Process with Free Dieless Deformation

Deformation Analysis of Double Wall Brazed Tube in the Multi-Pass Roll Forming: Cross-sectional Variation, Stress-Strain Evolution and Roundness Assessment

Influence of mechanical properties of tube on forming limits and deformation characteristics in expansion drawing process

Study on Forming Limit and Feasibility of Tube Axial Compressive Process

Research on Cross-Sectional Deformation of Double-Ridged Rectangular Tube During H-typed Rotary Draw Bending Process

Deformation Behavior of Convolute Thin-Walled AA6061-T6 Rectangular Tubes Manufactured by the Free Bending Forming Technology

Effect of Geometric Parameters on Folding of Thin-Walled Steel Tube under Axial Compression

Free deformation mechanism and change of forming mode in tube inversion under conical die

Forming Characteristics of Thin-Walled Tube Bending Process with Small Bending Radius

Plastic Deformation Characteristics Analysis in Rotary-Draw Bending Process of Thin-Walled Rectangular Tube

Failure Mechanism and Forming Limit of Tube Axial Compressive Process

Forming characteristics of thin-walled tubes manufactured by free bending process-based nontangential rotation bending die

Deformation Analysis of Double-Sided Tube Hydroforming in Square-Section Die

Plastic Deformation Mechanism in Double-Roller Clamping Spinning of Flanged Thin-Walled Cylinder

Influence of Mandrel Parameters on Cross-Sectional Deformation of H96 Double-Ridged Rectangular Tube with Ridge Groove Fillers in H-typed Rotary Draw Bending