The Structure and Tribological Properties of Gradient Layers Prepared by Plasma-Based Ion Implantation on 2024 Al Alloy
JX Liao,LF Xia,MR Sun,WM Liu,T Xa,QJ Xue
DOI: https://doi.org/10.1088/0022-3727/37/3/014
2004-01-01
Journal of Physics D Applied Physics
Abstract:Using plasma-based ion implantation, two types of gradient layers have been prepared on 2024 Al alloy. One is prepared by N-implantation then C-deposition, the other adds an interlayer composed of a Ti layer and a Ti–N layer between N-implantation and C-deposition. C-deposition is carried out at various implanting voltages or C2H2/H2 ratios. The composition depth profiles of these layers were characterized by x-ray photoelectron spectroscopy. The structure, morphologies and microstructure of the C layers were studied using Raman spectroscopy, atomic force microscope and transmission electron microscope, respectively. The surface hardness was measured with a Knoop tester and a mechanical property microprobe. The dry ball-on-disc wear tests were performed in ambient air. The gradient layer without interlayer is composed of an N-implanted layer rich in AlN and a diamond-like carbon (DLC) layer (film), and the two layers are connected with a C–Al transition layer containing Al4C3. The Ti layer rich in α -Ti and the N-implanted layer are connected by a Ti–Al transition layer containing TiAl3, while the Ti–N layer rich in TiN and the DLC film are connected by a C–Ti transition layer containing TiC, TiCN, etc. Thus, the gradient layer with interlayers has optimized the gradient structure. DLC films are compact and amorphous, contain high sp3/sp2 ratios and depend on the implanting voltage and the C2H2/H2 ratio. Similarly, these gradient layers exhibit significant improvement in morphologies, surface hardness and tribological properties; the interlayer, the implanting voltage and the C2H2/H2 ratio all have prominent effects on these properties.