Abstract:A Cu–Ni-based alloy with a high power factor is a commercially utilized metallic thermocouple material. However, the high thermal conductivity has been a major limitation to achieving thermoelectric performance in semiconductor materials. Herein, this work presents a 76.1% reduced thermal conductivity (∼7.7 W m–1 K–1) in Cu70Ni30, which is one of the lowest reported values in the literature. Such suppression of thermal conductivity can be attributed to the varied frequency phonon scattering by the interfacial potential barrier, built from micron-scale defects formed via sintering melt-spun ribbons. However, the defects simultaneously reduce the charge carrier concentration, mobility, and thus the electrical conductivity. The lowest thermal conductivity leads to the highest zT and ZTavg in the sample sintered at 673 K under 15 MPa. The values are 0.24 (@573 K) and 0.15 (323–573 K), respectively, which are 130.3 and 140.0% higher than the values of the pristine counterpart. Our work demonstrates that improved thermoelectric performance in Cu–Ni-based alloys can be obtained by creating various interfacial defects even at micron scales, which paves the way to suppress thermal conductivity largely in metallic thermoelectric materials via melt-spinning (MS) and spark plasma sintering (SPS) synthesis.The Supporting Information is available free of charge at https://pubs.acs.org/doi/10.1021/acsaem.2c00404.Additional EDS mapping images, SEM images, calculated κl and κe of Cu70Ni30-sintered bulks according to the Wiedemann–Franz law, fitting values a and b in eq 2, κl/κT of sintered bulks at 323 and 573 K, and Pisarenko plots (PDF)This article has not yet been cited by other publications.

Hypercooling and the thermodynamic properties of Cu-Ni alloys

Hypercooling and the Specific Heat Capacity of Cu-Ni Alloy

Rapid Solidification of Highly Undercooled Ni–Cu Alloys

Solidification Microstructure in a Supercooled Binary Alloy

The Growth Velocity-Undercooling Relationship of Highly Undercooled Ni and Ni-Cu Melts

Microstructure Refinement Mechanism of Undercooled Cu55Ni45 Alloys

Specific Heat Determination and Simulation of Metastable Ternary Ni80Cu10Si10 Alloy Melt

Effect of Minor Addition of Co on Nonequilibrium Solidification of Deeply Undercooled Cu Based Alloys

Investigation on nonequilibrium crystallization of highly undercooled Cu–Ni–Co alloys

Solidification Microstructure Evolution and Grain Refinement Mechanism under High Undercooling of Undercooled Ni90Cu10 Alloys

Growth Velocity-Undercooling Relationship and Structure Refinement Mechanism of Undercooled Ni-Cu Alloys

Molecular Dynamics Simulation of the Specific Heat of Undercooled Fe-Ni Melts

High Undercooling Effect on Magnetic Shape Memory Co–Ni–Ga Alloys

Molecular Dynamics Simulation of Thermophysical Properties of Undercooled Liquid Cobalt

Study on the microstructure evolution mechanism of copper single phase alloys under deep undercooling conditions

Mechanical properties of undercooled Cu70Ni30 alloy

DENUCLEATION AND HIGH UNDERCOOLING OF Ni-32.5%Sn EUTECTIC ALLOY

Multi-Interface-Induced Thermal Conductivity Reduction and Thermoelectric Performance Improvement in a Cu–Ni Alloy

Grain refinement in bulk hypercooled Ni50Cu50 alloy

A Molecular Dynamics Simulation of Thermodynamic Properties of Undercooled Liquid Ni2TiAl Alloy

Molecular Dynamics Studies on the Correlation of Undercoolability and Thermophysical Properties of Liquid Ni–Al Alloys