Abstract:Purpose The purpose of this paper is to conduct a comparative study of the surface modifications induced by two different lasers on a 2050‐T8 aluminum alloy, with a specific consideration of residual stress and work‐hardening levels. Design/methodology/approach Two lasers have been used for Laser shock peening (LSP) treatment in water‐confined regime: a Continuum Powerlite Plus laser, operating at 0.532 mm with 9 ns laser pulses, and near 1.5mm spot diameters; a new generation Gaia‐R Thales laser delivering 10 J‐10 ns impacts, with 4‐6mm homogeneous laser spots at 1.06 mm. Surface deformation, work‐hardening levels and residual stresses were analyzed for both LSP conditions. Residual stresses were compared with numerical simulations using a 3D finite element (FE) model, starting with the validation of surface deformations induced by a single laser impact. Findings Similar surface deformations and work‐hardening levels, but relatively lower residual stresses were obtained with the new large 4‐6 mm impact configuration. This was attributed to a reduced number of local cyclic loadings (2) compared with the small impact configuration (4). Additionally, more anisotropic stresses were obtained with small impacts. FE simulations using Johnson‐Cook's material' behavior were shown to simulate accurately surface deformations, but to overestimate maximum stress levels. Research limitations/implications This work should provide LSP workers a better understanding of the possible benefits from the different LSP configurations currently co‐existing: using small ( 4‐5 mm). Moreover, experimental results and simulated data had never been presented on 2050‐T8 Al alloy. Originality/value An experimental (and numerical) comparison using two distinct laser sources for LSP, has never been presented before. This preliminary work should help LSP workers to choose adequate sources.

LASER SHOCK PROCESSING OF SMALL HOLE

Laser shock-processing for fatigue and fracture resistance

Methods for the suppression of “residual stress holes” in laser shock treatment

Progress in applications of shockwave induced by short pulsed laser on surface processing

3-D FEM simulation of laser shock processing

Study of Mechanism of Strengthening Materials with Laser Shock Processing

Numerical Simulation Research on Laser Shock Forming of Thin Metal Sheet

Study on the composite strengthening with laser shock processing and ultrasonic extrusion strengthening for small hole components

Laser Parameters in Laser Shock Processing:Research Progress and Prospect

Laser Shock Processing of Ni-Base Superalloy and High Cycle Fatigue Properties

Processing of Micro-Hole by Millisecond Laser and Post Processing of Recast Layer

Overlapping rate effect on laser shock processing of 1045 steel by small spots with Nd:YAG pulsed laser

Effect of Laser Shock Processing on Mechanical Properties of Al-Li Alloy

Study on Residual Stress of Laser Shock Processing Based on Numerical Simulation and Orthogonal Experimental Design

Experimental study on the pressure characteristics of laser-induced shock waves under different energy distribution

Simulation of the elasto-plastic response and residual stresses near metal surface due to laser shock processing

Stepwise varying of laser parameters to enhance the residual stress field in multiple laser shock processing: numerical verification of single-point region

Measurement on the Peak Pressure of Shocking Wave Induced by Laser and Experimental Researches on Strengthening Aviation Al-Alloy by Laser Shocking

Fatigue life and fracture evolution of small-hole specimens by laser shock processing

Optimization Of Residual Stresses Induced By Multiple Laser Shock Processing

Laser shock processing with two different laser sources on 2050‐T8 aluminum alloy