Abstract:Particle size and content of RDX are the two main factors that affect the burning stability of RDX-based propellants. However, these effects and the corresponding mechanisms are still controversial. In this work, we investigated the physicochemical processes during burning and the corresponding mechanisms through the technologies of structure compactness analysis on the base of voidage measurement and theoretical interfacial area estimation, apparent burning rate measurement using closed vessel (CV) and extinguished burning surface characterization relying on interrupted closed vessel (ICV) and scanning electron microscope (SEM). The results indicate that the voidage increased with the increase of RDX content and particle size due to the increasing interfacial area and increasing interface gap size, respectively. The apparent burning rate increased with the increase of RDX particle size because of the decreasing RDX specific surface area on the burning surface, which could decrease the heat absorbing rates of the melting and evaporation processes of RDX in the condensed phase. Similarly, the apparent burning rate decreased with the increase of RDX content at pressures lower than around 55 MPa due to the increasing RDX specific surface area. Whereas, an opposite trend could be observed at pressures higher than around 55 MPa, which was attributed to the increasing heat feedback from the gas phase as the result of the increasing propellant energy. For propellants containing very coarse RDX particles, such as 97.8 and 199.4 μm average size, the apparent burning rate increased stably with a flat extinguished surface at pressures lower than around 30 MPa, while increased sharply above around 30 MPa with the extinguished surface becoming more and more rugged as the pressure increased. In addition, the turning degree of <em>u</em>-<em>p</em> curve increased with the increase of coarse RDX content and particle size, and could be reduced by improving the structure compactness.

A STUDY ON THE IGNITION PROPERTIES OF WET ULTRAFINE RDX POWDER

Ultrafine RDX / Al Preparation and Properties of Mixed Explosives

Preparation and impact sensitivity of ultrafine RDX/Ni mixed explosives

Preparation,Characterization and Performances of High Purity Sub-micron RDX

Effects of particle size and content of RDX on burning stability of RDX-based propellants

Namerical Simulation on Factors Affecting Ignition Characteristics of A New Engine

Study on Thermal Properties and Sensitivities of Nano-RDX

Preparation of Ultra-Fine Explosive HMX and RDX Using High-Speed Impinging Streams

Effect of RDX Powders on Detonation Characteristics of Emulsion Explosives

Study on Dynamic Impact and Ignition Response Behavior of GAP/PET/RDX Based Propellant

Study of Technology on the Preparation of Ultrafine Particle of Explosive Using the Technology of High-speed Impinging Streams

Experimental Study on Single Ignition of Multi-Component Fuel Mixture

Effects of Vacuum Degree on the Detonation Characteristics and Energy Release Laws of RDX Explosive

Effect of low-concentration RDX dust on solid–liquid mixed fuel characteristics

Influence of Particle Size, Morphology and Size Distribution on the Safety and Thermal Decomposition Properties of RDX

A Systematic Method to Determine and Test the Ignition and Growth Reactive Flow Model Parameters of a Newly Designed Polymer‐Bonded Explosive

A new insight into the mechanical behavior of high-quality RDX in pressed polymer bonded explosives

The Auto‐Ignition Behaviors and Thermal Safety of the Composite Modified Double Base Propellants under Rapid Heating

Experimental Study on Single Ignition of Mixed Ternary Fuel

A feature on ensuring safety of superfine explosives

Technology of Ultra-fine RDX Coating with Rapid Expansion of Supercritical Solution Method