Abstract:Cam-lobe radical-piston hydraulic motors can achieve ultrahigh power rotary output (up to megawatts), which are widely used in tunnel boring machines, dredgers, and other high-end equipment. In these applications, hydraulic motors always operate in complex and drastically changing conditions, causing their key roller-piston friction pairs to be vulnerable to wear and failure. However, there is a lack of easy-to-use and low-cost testing instruments to investigate the failure behavior of friction pairs and verify the reliability of the developed friction pairs. For that, this study developed a quasi-actual mechatronic instrument that can realistically reproduce various actual operating conditions to achieve quasi-actual testing of the friction pair. This instrument is composed of three parts: a testing bench, a hydraulic system, and a control system. The hydraulic system with a proportional relief valve is responsible for adjusting the hydraulic pressure on the piston in the testing bench, while the roller speed is controlled by a servo motor in the testing bench. To realize the quasi-actual control, an improved fuzzy PID and PI control algorithms embedded in the control system are proposed to real-time regulate the hydraulic pressure and roller speed, respectively. Finally, several quasi-actual testing experiments are conducted to reproduce different operating conditions of roller-piston friction pairs in a tunnel boring machine. The experimental results show that quasi-actual hydraulic pressures and roller speeds obtained from the developed mechatronic instrument are in good agreement with the actual operating data from the tunnel boring machine, indicating that the mechatronic instrument offers a feasible, easy-to-use, and quasi-actual way for testing roller-piston friction pairs.

A New Continuous Rotary Electro-hydraulic Servomotor Applied to Simulator

Research on Design of Super-low-speed Continuous RotaryElectro-hydraulic Servomotor Applied to Simulator

METHOD OF SERIAL CONTROL TO IMPROVE DYNAMIC RESPONSE OF THE ELECTRO-HYDRAULIC POSITION SERVO SYSTEM

Modeling and Analysis of Hydraulic Controlled Rotary Valve Excitation System

Design of a New Electrohydraulic Control System for Segment Rotational Motion

Paralleling Hydraulic Control of Variable Frequency Motor and Valve for the Swing Mechanism of Segment Erector

A Fast Integral Sliding Mode Controller with an Extended State Observer for Position Control of Permanent Magnet Synchronous Motor Servo Systems

Emulation and Research of the Fast Electro-hydraulic Actuator

PID–PFC control of continuous rotary electro‐hydraulic servo motor applied to flight simulator

Precision Motion Control of a Servomotor-Pump Direct-Drive Electrohydraulic System With a Nonlinear Pump Flow Mapping

Experimental Study on SMC Series Cylinder of CE1 Pneumatic Servo System

STUDY ON THE HIGH PERFORMANCE LINEAR SERVO SYSTEM FOR MIDDLE-CONVEX AND VARYING ELLIPSE PISTON MACHINING

A Quasi-Actual Mechatronic Instrument for Realistically Testing Roller-Piston Friction Pairs

Modeling and Optimal Design of the Rotary-Linear Type Two-Degree-of-Freedom Ultrasonic Motors

An Integrated Trajectory Planning and Motion Control Strategy of a Variable Rotational Speed Pump-Controlled Electro-Hydraulic Actuator

Development of a Linear Electrostrictive Servo Motor

Dynamic Response Analysis of Control Loops in an Electro-Hydraulic Servo Pump Control System

Simulation and Implementation of Servo Control System for Electro-hydraulic Hybrid Injection Molding Machine

Simulation and Design of Servo-system With Permanent Magnet Synchronous Motor Based on Torque-angle Control

Simulation research on the variable displacement hydraulic motor with variable effective piston stroke for hydraulic propulsion system

A Study on the Electro-Hydraulic Coupling Characteristics of an Electro-Hydraulic Servo Pump Control System