Abstract:The welding property was decided by the physical characteristic of the arc plasma, and the dynamic property of two-element arc plama which was produced by pulse tungsten inert gas welding(P-TIG) with hybrid shielding gas was analyzed, which provides a theoretical basis for further research on the physical process of weld in hybrid gas shielded welding. Argon-nitrogen arc plasma was used to improve penetration since it has high thermal property, but demixing during welding complicated its physical characteristic. Spectral diagnosis is the most important means to measure the physical characteristics of arc plasma, but the further research on the arc characteristics of P-TIG welding with hybrid sheilding gas is still needed, especially during the arc ignition time. In this paper, an argon-nitrogen arc plasma produced by P-TIG welding during arc ignition is studied, the highspeed camera experiment system is proposed to collect the dynamic spectrum information of arc plasma, and the dynamic intensity of Ar I 794.8 nm and N I 904.6 nm under P-TIG welding arc was obtained; temperature and concentration of 1, 2, 3 and 4 mm under tungsten during arc ignition were calculated by Fowler-Milne method; and the physical characteristics of 80%Ar+20%N-2 shielded P-TIG welding arc plasma were quantitatively analyzed. The results show that the change of arc intensity, temperature and concentration is synchronized with the current. The welding current reaches a stable state within 3 ms, while the intensity, temperature and concentration of the arc plasma take longer time to reach equilibrium state. From arc ignition to steady burning, the arc intensity presented a trend of increasing first and then decreasing during the base and peak period. As a result of changes in heat conduction and current density of the cathode, the peak temperature and base temperature in the axial position of arc plasma increase rapidly and then decrease slowly. Due to the impact of particles collision and friction, the concentration of argon decreases rapidly and increases slowly during both the peak and the base period of arc plasma, and is lower than the original value.

Investigation on Analogue Insulated Gate Bipolar Transistor Power Source of Gas Tungsten Arc Welding with Touch Igniting Technique

Study on welding power source used in intelligent control system for weld pool shape in pulsed GTAW

Study on the measure to improve the arc stabilization in smaller current welding for the variable polarity GTAW power source

Investigation on Tiny Current Automatic Touch-starting Method of All-position Narrow Gap and Thick-walled Pipe Welding

Study on control system for MMA welding power source

TIG Arc-Induced Non-Contact MIG Arc Ignition

The trench Insulated Gate Bipolar Transistor— a high power switching device

Spectroscopic analysis of the arc plasma during activating flux tungsten inert gas welding process

Variable Polarity TIG Welding Arc Dynamic Analyzer

Research of IGBT Inverter Low Spatter CO2 Welding Machine

Secondary Inverter Topologies of the Variable Polarity GTAW Power Supply and Their Relevant Control Strategies

Effect of dry hyperbaric GMAW arc characteristic on welding power control algorithm

Study on three-dimensional output characteristic control for welding arc

Stability Analysis of Metal Active-Gas Welding Short-Circuiting Transfer Based on Input Pulsating Energy

A study on twin-tungsten TIG welding method

Transient characteristics of ultra-high frequency adjustable multi-pulse gas tungsten welding arc

Development of Carbon Dioxide Welding Machine with Insulated-Gate Bipolar Transistor Inverter Controlled by Microcomputer

Selection and application of IGBT in weld power source

Metal transfer electrical characteristics and its analysis in pulsed current gas metal arc welding

Power Loss and Temperature Rise Model for an IGBT in a Variable Polarity Welding Power Supply with a Reverse Voltage Stabilizer

Dynamic Diagnostic of Physical Property in P-TIG Argon-Nitrogen Shielded Arc Plasma with Optical Emission Spectrometry