Abstract:In the present study, detailed numerical simulations are performed to investigate the primary breakup of a gasoline surrogate jet under non-evaporative "Spray G" operating conditions. The Spray G injector and operating conditions, developed by the Engine Combustion Network (ECN), represent the early phase of spray-guided gasoline injection. To focus the computational resources on resolving the primary breakup, simplifications have been made on the injector geometry. The effect of the internal flow on the primary breakup is modeled by specifying a nonzero injection angle at the inlet. The nonzero injection angle results in an increase of the jet penetration speed and also a deflection of the liquid jet. A parametric study on the injection angle is performed, and the numerical results are compared to the experimental data to identify the injection angle that best represents the Spray G conditions. The nonzero injection angle introduces an azimuthally non-uniform velocity in the liquid jet, which in turn influences the instability development on the jet surfaces and also the deformation and breakup of the jet head. The asymmetric primary breakup dynamics eventually lead to an azimuthal variation of droplet size distributions. The number of droplets varies significantly with the azimuthal angle, but interestingly, the probability density functions (PDF) of droplet size for different azimuthal angles collapse to a self-similar profile. Analysis has also been conducted to estimate the percentage and statistics of the tiny droplets that are under resolved in the present simulation. The PDF of the azimuthal angle is also presented, which is also shown to exhibit a self-similar form that varies little over time. Finally, a model is developed to predict the droplet number as a function of droplet diameter, azimuthal angle where a droplet is located, and time.

Experimental Study on the Unsteady Transverse Injection of Diesel into a Subsonic and Supersonic Flow

Experimental Analysis in Dynamics Characteristics of Impinging Spray by a PFI Injector : from Spray Atomization to Fuel Adhesion Formation

Experimental study on the break characteristics of diesel fuel injection by pressure

Spray Trajectory and 3D Droplets Distribution of Liquid Jet in Crossflow with Digital Inline Holography

Experimental Study on Microscopic and Macroscopic Characteristics of Diesel Spray with Split Injection

Ultra-High Speed Imaging Study of the Diesel Spray Close to the Injector Tip at the Initial Opening Stage with Single Injection

The Effect of Bubbles on Primary Breakup of Diesel Spray

The breakup and instability structures of liquid jets in subsonic crossflows

Shock Wave Research in Diesel Jet

The Primary Breakup and Atomization Characteristics of Liquid Jet in Crossflow at the Fixed Momentum Ratio and Weber Number

Study on atomization characteristics of a kerosene jet in a supersonic crossflow

Microscopic Study on the Mechanisms for Formation of the Initial Spray Morphology

Experimental Investigation on Effect of Gas/spray Interactions on Transient Diesel Spray Behaviors

Experimental investigation of the characteristics of direct injection nozzle sprays in an afterburner environment

An Experimental and Numerical Study of Diesel Spray Impingement on a Flat Plate

Modeling and Detailed Numerical Simulation of the Primary Breakup of a Gasoline Surrogate Jet under Non-Evaporative Operating Conditions

Spray Dynamics of High Pressure Fuel Injectors for DI Gasoline Engines

Experimental study on spray characteristics of six-component diesel surrogate fuel under sub/trans/supercritical conditions with different injection pressures

Nozzle Internal Flow and Spray Primary Breakup with the Application of Closely Coupled Split Injection Strategy

Experimental Study on Atomization Phenomena of Kerosene in Supersonic Cold Flow

Near-nozzle Microscopic Characterization of Diesel Spray under Cold Start Conditions with Split Injection Strategy