Tribological Properties of SiC Particle Filled in Monomer Cast Nylon

LI Guolu,WANG Kunlin,CUI Zhouping,LIU Jiajun

DOI: https://doi.org/10.3321/j.issn:1000-0054.2000.04.031

2000-01-01

Abstract:Effects of SiC particles as fillers on the friction and wear properties of monomer cast nylon (MC nylon) were studied using two kinds of MC nylon with and without SiC particles. The properties were measured on a MM 200 model friction and wear test machine. The morphology of the worn surface was observed by a scanning electron microscope (SEM). The wear mechanism indicated by the observetion was discussed. The results show that the tribological properties of the SiC particle filled MC nylon is related to the product of the load and the sliding velocity for dry friction. The friction coefficient of the composite is larger than that of pure nylon. When the load velocity product is low, the wear resistance of the composite is better than that of pure nylon and its wear mechanisms of the composite may be abrasive wear and adhesive wear. When the load velocity product is higher, the wear resistance of the composite is worse than that of pure nylon and its wear mechanisms may be fatigue delamination, abrasive wear and adhesive wear. With water lubrication, the SiC particle filled MC nylon has better wear resistance and the load velocity product has little effect on its tribological properties. The main wear mechanism of the composite with water lusucatia is abrasive wear.