Abstract:Intersections and discontinuities commonly arise in surface modeling and cause problems in downstream operations. Local geometry repair, such as cover holes or replace bad surfaces by adding new surface patches for dealing with inconsistencies among the confluent region, where multiple surfaces meet, is a common technique used in CAD model repair and reverse engineering. However, local geometry repair destroys the topology of original CAD model and increases the number of surface patches needed for freeform surface shape modeling. Consequently, a topology recovery technique dealing with complex freeform surface model after local geometry repair is proposed. Firstly, construct the curve network which determine the geometry and topology properties of recovery freeform surface model; secondly, apply freeform surface fitting method to create B-spline surface patches to recover the topology of trimmed ones. Corresponding to the two levels of enforcing boundary conditions on a B-spline surface, two solution schemes are presented respectively. In the first solution scheme, non-constrained B-spline surface fitting method is utilized to piecewise recover trimmed confluent surface patches and then employs global beautification technique to smoothly stitch the recovery surface patches. In the other solution scheme, constrained B-spline surface fitting technique based on discretization of boundary conditions is directly applied to recover topology of surface model after local geometry repair while achieving G 1 continuity simultaneously. The presented two different schemes are applied to the consistent surface model, which consists of five trimmed confluent surface patches and a local consistent surface patch, and a machine cover model, respectively. The application results show that our topology recovery technique meets shape-preserving and G 1 continuity requirements in reverse engineering. This research converts the problem of topology recovery for consistent surface model to the problem of constructing G 1 patches from a given curve network, and provides a new idea to model repairing study.

Continuity of Non-Uniform Recursive Subdivision Surfaces

Coarsened C1-continuous Shape Functions Using B-spline Patches for Simulating Nonlinear Heterogeneous Structures

Point-normal Subdivision Curves and Surfaces

Non-uniform recursive Doo–Sabin surfaces

Global Continuity Adjustment and Local Shape Optimization Technique for Complex Trimmed Surface Model

Exact Evaluation of NURSS at Arbitrary Parameter Values

Conditions Of G(N) Continuity Between Surfaces

Non-uniform Subdivision Approach for Free-Form Curves and Surfaces of Arbitrary Degree

On Regularity of Catmull-Clark Subdivision Surfaces

Local Consistent Mending Technique for Complex Freeform Surface Model

Construction of G~1/C~2 continuous B-spline surfaces over arbitrary quadrilateral network

NURBS Surface Fairing Based on Non-uniform B-spline Multi-resolution Wavelet Decomposition

Topology Recovery Technique for Complex Freeform Surface Model after Local Geometry Repair

Isogeometric Analysis for the Scattering of NURBS Surfaces with Coinciding Knots

Gn Conditions Between Two Bezier Surfaces

Catmull-Clark Subdivision Surfaces with Parameters

Semi-stationary Loop Subdivision Scheme

Constructing Iterative Non-Uniform B-spline Curve and Surface to Fit Data Points

Precise Evaluation of Uniform Doo-Sabin Surfaces

C2 Continuous spline surfaces over Catmull-Clark meshes

Discrete Differential Geometry for $C^{1,1}$ Hyperbolic Surfaces of Non-Constant Curvature