Abstract:This paper compares the popular control methods for two dominant types of active power filters (APFs). With the equivalent transformation of their control diagrams, the recently proposed current-source control method for series active power filter (SAPF) is revealed to have the same control structure as the traditional voltage-source control method therefore have same compensation performances. Similarly, two kinds of popular control methods for parallel active power filter (PAPF) are also compared and found to have the similar control structure. The recently proposed PAPF control scheme without harmonics detection is revealed as a reduced version of the traditional control scheme with harmonics detection. Therefore both have same basic control principles regarding load current harmonics compensation. A general expression of the control methods for PAPF is then proposed in the form of both a control diagram and a set of equations based on current detection. With a particular set of filter gains of the three detected currents, each particular control scheme can be specifically identified and described by the general expression. Subsequently the 64 possible sets of filter gains are examined by the proposed necessary conditions to locate practically valid control schemes. Finally 4 valid control schemes come out and among which some are schemes that have never been reported before. With the comprehensive comparison of the control methods and the proposed general expression in this paper, the essential relationships of the control methods are revealed, some misinterpretations from previous publications are clarified, and some new control schemes are obtained.

General principle of active power filter and its application

A Hybrid Solution To Active Power Filter For The Purpose Of Harmonic Suppression And Resonance Damping

Analysis of a Novel Hybrid Series Active Power Filter Topology

A New Hybrid Active Power Filter Topology with Continuous Compensation Bandwidth and Small Active Capacity

Generalized Control Approach for Active Power Filters

New Hybrid Active Power Filter with Low Additive Reactive Current Injection

Modeling and Design of the Output Filter Applied to High Power Shunt Active Power Filters

Status quo of active power filter technology

Control Techniques for Active Power Filters

The Design of Active Power Filter with Parallel Structure

Design and Application of Transformerless Shunt Hybrid Active Power Filter

A Series Active Power Filter Adopting Hybrid Control Approach

A three-phase four-wire three-level active power filter based on one-cycle control

Design and implementation of compound current control strategy for improved LCL-based Shunt Active Power Filter

THE C TYPE HYBRID ACTIVE POWER FILTER

Analysis and Suppression of Conductive EMI Originated by an Active Power Filter

Active Power Filter for Harmonie Compensation Using a Digital Dual-Mode-structure Repetitive Control Approach

Study on Shunt Active Power Filter with High Quality Grid Current Waveform

A Novel Active Power Filter for High Voltage Application

A simple method of realization of low power loss and high compensation-precision active power filter

On the control of active power filters