Abstract:This paper proposes an online identification method utilizing phasor measurement unit measurements, symmetric dot pattern graphs, and the ResNet50‐L1 M model to facilitate the rapid identification of metering relative errors among interconnected capacitor voltage transformers (CVTs) in wide‐area substations within power systems. The effectiveness of the proposed method was evaluated using data from the "Houshou transmission line" in Ningxia province. With 16 different error states tested, the model achieved an identification accuracy rate of 89.39%. This paper proposes an online identification method utilizing phasor measurement unit (PMU) measurements, symmetric dot pattern (SDP) graphs, and the ResNet50‐L1 M model to facilitate the rapid identification of metering relative errors among interconnected capacitor voltage transformers (CVTs) in wide‐area substations within power systems. First, PMUs measured the three‐phase voltage data from interconnected CVTs across wide‐area substations. The amplitude differences of the three‐phase voltages were converted into Euclidean distances, which were then transformed into SDP graphs, with each type of metering relative error corresponding to a distinct SDP graph. The ResNet50‐L1 M model was established by integrating an L1 norm‐based attention mechanism into the ResNet50 architecture. This model was then trained on CVT SDP graphs representing various error states to develop an online error identification system. The effectiveness of the proposed method was evaluated based on data from the "Houshou transmission line" in Ningxia province, which connects the 330 kV Niushoushan substation and the 330 kV Houqiao substation operated by the State Grid Corporation of China. With 16 different error states tested, the model achieved an identification accuracy rate of 89.39%, demonstrating a notable improvement over other methods in comparative tests.

IDENTIFICATION OF RESIDUALS CONTAMINATION BASED ON SIGNS OF MEASUREMENT RESIDUALS

ON-LINE IDENTIFICATION OF POWER SYSTEM DYNAMIC EQUIVALENT Part Three Analysis of Several Important Issues

Identification Based Fault Detection: Residual Selection and Optimal Filter

Identification of Bad Measurements in Power System from Historical Measurement Data

A New Approach for Detection and Identification of Multiple Bad Data in Power System State Estimation

Network Parameter Identification and Estimation Based on Hybrid Measurement of WAMS/SCADA

A New Iterative Identification and Control Method of Closed-Loop Power System Based on Ambient Signals

A NEW CRITERION OF DETERMINING MEASUREMENT WEIGHTS IN POWER SYSTEM STATE ESTIMATION

Why Conventional Detection Methods Fail in Identifying the Existence of Contamination Events

Abductive Identification of Bad Data: Methodology and Field Test

A New Method Of Bad Data Detection And Identification In Distribution Networks

Research of Fine and Robust State Estimation

An Online Contaminant Classification Method Based on MF-DCCA Using Conventional Water Quality Indicators

Performance Evaluation for Three Pollution Detection Methods Using Data from a Real Contamination Accident.

Dynamic State Estimation Method for Generator Considering Measurement of Bad Data

Reliability assessment of power systems considering reactive power sources

Contamination Event Detection Method Based On The Longest Common Subsequence Analysis Using Multiple Water Quality Parameters

A New State Estimation Method with Bad Data Rejection Properties

An online method for identifying metering relative errors in wide‐area interconnection CVTs using PMU measurements, SDP graphs, and ResNet50‐L1M

Identification Of Constant Contaminant Sources In A Test Chamber With Real Sensors

A fast method for identifying bad data of massive power network data