The maximal strike-slip cumulative displacement in the Altyn Tagh fault zone - 900 km (?)
Li Haibing,Yang Jingsui,Wu Cailai,Zhang Jianxin,P. Tapponier
IF: 3
2001-01-01
Journal of Asian Earth Sciences
Abstract:The Altyn Tagh fault is located at the northern boundary of the Qinghai-Tibet Plateau and is the largest sinistral strike-slip fault in the continent of Asia. The maximal strike-slip displacement of the fault is a difficult but interesting question for understanding the tectonic activity on the north border of the plateau. Normally, the blocks older than the fault may record the maximal strike-slip displacement. Therefore, we need to find comparable geological bodies on the two sides of the fault, and to know the movement of different blocks by the fault and the formational age of the fault as well. After a series of comparative research in the morphological structural geometry, petrology and regional tectonics, we put forward that: The maximal strike-slip displacement of the Altyn Tagh fault is represented by the ductile and the brittle displacements, and the ductile deformation covers the area between the Altyn Tagh fault and the Qiemo-Heijianshan fault. A big angle exits between the near EW-striking high-pressure metamorphic eclogite belt on West of the Altyn Tagh fault and the NW-striking high-pressure metamorphic eclogite belt on East of the Altyn Tagh fault, probably belonging to part of the folding traction or striking drag produced in the course of ductile and ductile-brittle striking. The west part of the eclogite belt on the West of the Altyn Tagh fault was most likely transected by the Qiemo-Heijianshan fault and the Luobuzhuang-Xingxingxia fault, and probably will be seen West Kunlun. The Proterozoic metamorphic basement of the Altun Group in the Altun region is very similar to that of the Tiekelike Group in the West Kunlun region, as well as to that of the Dakendaban Group in the North Qiadam region. The Kudi-Subashi ophiolites in West Kunlun, the ophiolites in the southern slope of the Altun region, and the ophiolites in the North Qiadam region have the same Early paleozoic age, and all these ophiolites contain low potasium tholeiite, show similar REE distribution pattern, suggesting that they most likely be a same ophiolite belt. The Kangxiwa fault was the western extension of the East Kunlun fault but was transected by the Altyn Tagh fault. The West Kunlun orogenic belt represents the west extension of the compound of the northern Qiadam mountain and the East Kunlun mountain. We take the ophiolitic melange zone the eclogite zone and the large-scale strike-slip fault as the different indicators and carry out the estimation on the strike-slip displacement along the direction of the Altyn Tagh fault (Fig. 1). The ophiolitic melange zone in the northern Qilian, the high-pressure metamorphic eclogite zone in the northern Qiadam and the East Kunlun (strike-slip) fault zone on the eastern side of the Atlyn Tagh fault, are corresponded to the Horgliugou ophiolitic melange zone, the Altyn high-pressure metamorphic eclogite zone and the West Kunlun zone (?), and the Kangxiwar (stike-slip) fault zone on the western side of the Altyn Tagh fault, respectively. Parts of the Altun mountain are situated in the ductile strike-slip traction. The estimated emplacement of the Altyn Tagh fault may be much less than it was if only simply correspond the tectonic units on the two sides of the fault. In contrast, the amount of the displacement is much close to the real value if the strike-slip traction is avoided. Thus we take the corresponding tectonic units at the two sides away from the fault for emplacement calculation. Also, we added the ductile strike-slip deformation as a factor into calculation. After compared the North Qaidam eclogite belt with the West Kunlun orogenic belt, we obtained a conclusion of 900 km emplacement, which is regarded as the maximal strike-slip cumulative displacement of the Altyn Tagh fault.